Brake fluid flush is an important part of maintaining your car’s braking system. By flushing the brake fluid regularly, you can ensure that the system is operating at its best and that any potential issues with the fluid are identified and corrected as soon as possible.
What is brake fluid flush?
Brake fluid flush is a maintenance procedure that is typically performed every 7,500 miles or every three years, whichever comes first. It’s important to flush the brake fluid regularly because brake dust and other debris can accumulate over time and cause the brake system to malfunction.
When should you do a brake fluid flush?
There is no one answer to this question since brake fluid flush requirements will vary depending on the make and model of your car, how often you use your brakes, and how dirty the brake fluid is. However, generally speaking you should do a brake fluid flush every 3 months or 6,000 miles, whichever comes first.
Benefits of brake fluid flush
Brake fluid flush is a great way to keep your car’s brakes working optimally. Here are some of the benefits:
1. Keeps Your Brakes Working at Their Best
A brake fluid flush is a great way to keep your car’s brakes working at their best. By flushing the system regularly, you’ll ensure that the brake pads and discs are always in good condition. This will help you avoid any potential problems, such as broken brake lines or warped rotors.
2. Prevents Build-Up of Dust and Dirt
Brake fluid flush also helps to prevent build-up of dust and dirt on the brake pads and discs. This can lead to decreased performance and increased wear on your brakes. By flushing the system regularly, you can help to avoid these problems and keep your car’s brakes performing optimally.
3. Helps to Keep Your Brakes Quiet
Brake fluid flush can also help to keep your brakes quiet. By flushing the system regularly, you’ll reduce the amount of noise that is produced by your brakes. This will help to reduce the risk of accidents and make driving more comfortable for you and your passengers.
What to do before and after a brake fluid flush
Prepping for a brake fluid flush:
1. Make sure your brakes are working properly by pressing and holding the brake pedal to the floor and pulling the emergency brake handle. If there is any braking noise or feel abnormal, your brakes may need to be serviced.
2. Remove any foreign objects from around your brake calipers ( dust, dirt, etc.).
3. Check your brake pads for wear and replace them as needed.
4. Clear any debris or rust from your master cylinder reservoir (if applicable). If your reservoir is clear, add new brake fluid to the reservoir and fill the bottle up to the “MAX” line with fresh fluid. Do not overfill it! Brake fluid can explode if it gets too high in pressure!
5. Disconnect your negative battery cable before proceeding.
6. Remove your wheel/tire/rim from the car by removing the hubcap and then grasping the tire and spinning it until it comes off of the wheel. Save this part! You will need it to reattach the new one later on (assuming you have a spare).
7. Open your car’s hood and locate your brake lines (they will be near the front of your car).