One of the most common car problems is a failure to stop on a dime when you need it to. This can be caused by a number of things, but one of the most common culprits is a faulty brake system. If you’re having trouble stopping on a steep hill, or you’re just concerned about your car’s overall safety, here’s how to check your brake fluid and flush it if necessary.
What is Brake Fluid and What Does It Do?
Brake fluid is a fluid that is used to stop the wheels from skidding on the road. It is made up of different chemicals and minerals that work together to create a slippery surface on the wheel. This allows the car to stop quickly without losing traction.
Brake fluid is usually flushed every time you replace your brakes. Replacing the brake pads and discs also requires you to flush the brake fluid. Flushing the brake fluid helps to remove any debris or mineral deposits that may have built up over time.
How to Check and Flush Brake Fluid
If your Audi A has a manual transmission, you should check the brake fluid level and flush it if it is low or if the fluid has been spilled. To check the brake fluid level, first make sure that the parking brake is set. Then remove the cover on the right rear wheel hub. The brake fluid reservoir can be seen just below this cover. Turn the wheel to see if any of the brake fluid comes out. If it does, stop driving and have your Audi dealer service the brakes. If you are unsure how to check and flush the brakes, your Audi dealer can help you.
If your Audi A has an automatic transmission, there is no need to check the brake fluid level. However, if the fluid has been spilled, you should clean it up as soon as possible and have your Audi dealer service the brakes.
Which Audi AModels Require Brake Fluid Flushing?
If your Audi A has an automatic transmission, it may require brake fluid flushing. Here is a list of Audi A models that may require this service:
– Audi A4 (2003-2008)
– Audi A5 (2005-2009)
– Audi A6 (2004-2008)
– Audi S4 (1999-2005)
– Audi S5 (1999-2005)
If your Audi A has a manual transmission, you will not need to flush the brake fluid.
Conclusion
If your Audi A4 has recently been serviced and the brake fluid was replaced, it is important to flush the system once every two years or 20,000 miles. To do this, simply mix 1 gallon of fresh brake fluid with 1 gallon of cool water and pour it into the reservoir. Fill up the reservoir to the top of the arrow on the dashboard and turn on the car. Let it run until all of the fluid has been drained and then turn off the car. Wait at least 10 minutes before driving again.