Brake lines, also known as brake hoses, are important components of your car’s braking system. If they become clogged or kinked, your car’s brakes may not work properly. In this article, we’ll show you how to flush brake lines on a Honda Civic.
Detailed Instructions
If you are having trouble flushing brake lines on your Honda Civic, follow these detailed instructions. First, remove the wheel and tire. Next, remove the front bumper cover. Finally, remove the lower front fascia.
1) Remove the wheel and tire.
2) Remove the front bumper cover.
3) Remove the lower front fascia.
4) Locate and remove the Brake Line Flush Valves (2). There are two of them located on each side of the brake line reservoir (3).
5) Open the Brake Line Flush Valves (2), then pour a small amount of brake fluid into the reservoir (3). Be sure to fill it up to the “Brake Line Fluid Level” markings (4). Close both valves (2).
6) Reconnect all four bolts that hold the lower front fascia in place. Torque them to 18 ft-lbs.
7) Replace the lower front fascia and reattach the four bolts. torque them to 36 ft-lbs.
What To Do If You Don’t Have Brake Fluid
If you don’t have brake fluid, you can flush the lines with a garden hose. Make sure the Honda Civic is on a level surface and remove the front wheel. Loosen the bleed screw on each caliper and open the bleeder valve. Pump the brake pedal until all the brake fluid comes out of the system. Close the bleeder valve and tighten the bleed screw on each caliper. Reattach the front wheel and repeat steps 3-5 for the rear brakes.
How to Remove Brake Lines on a Honda Civic
If you’re having trouble stopping your Honda Civic, it might be time to flush the brake lines. Brake lines are important components of your car’s braking system and need to be replaced when they start to break down. Here’s how to do it:
1) Park your Honda Civic in a safe place, away from traffic.
2) Remove the wheel and tire.
3) Locate the brake line(s) on the brake calipers.
4) Loosen the fittings on each end of the brake line by turning them counterclockwise with a wrench.
5) Force the brake line out of the caliper by pushing down on one end and pulling up on the other.
6) Discard the old brake line.
7) Install the new brake line by tightening the fittings onto each end of the line with a wrench.
Conclusion
If you’re experiencing a “pinging” noise coming from your Honda Civic’s brake lines, it’s time to take action. Flushing the brake lines will eliminate any obstructions and stop the annoying noise. Here are instructions on how to do it:
1) Park your car in a safe location with plenty of room to work. Disable the parking brakes if you have them installed.
2) Remove the front wheel and inner hubcap.
3) Disconnect both hoses from the master cylinder (the large black rubber tank near the rear of the car).
4) Remove the two bolts that hold each line bracket in place – these will allow you to swing each line out of its respective bracket.
5) Wash all surfaces around each line with soapy water and fresh air – this will remove any dirt, oil, or grease that may have accumulated over time.
6) Connect one end of each hose to one side of a bucket or container big enough to hold at least 2 gallons of water (plus some extra for flushing). Turn on the faucet full blast and wait until the water starts flowing quickly down into the bucket before closing off both ends of the hose.