If you’re like most drivers, you probably know not to use your brake pedal when your car is in park – because if you do, your car’s brake system will release all the brake fluid it’s holding, and you’ll end up with a very expensive repair bill. But what about when you’re driving? How do you get the brake system to release the fluid?
What is Brake Fluid?
Brake fluid is a fluid that is used to help stop the wheels from locking up when you brake. It is a type of fluid that is used in many different types of cars.
Brake fluid comes in two different types: DOT (DOT 4) and ABS (ABS). DOT brake fluid is designed for use in street cars and light trucks. ABS brake fluid is designed for use in heavy vehicles, such as buses and trucks.
To flush your brake system, you will need to remove the wheel and drain the old brake fluid. You can then replace the brake fluid with the correct type, using the instructions that came with your car. Be sure to check the manufacturer’s website for more information on how to flush your brake system.
How to flush brake system for DOTbrake fluid
If you have a DOT brake fluid system, it is important to flush the brake system every 3-5 years. This will keep the brake system in good condition and increase braking efficiency.
To flush the brake system, you will need to remove the hood of the car and locate the brake line connection point. You will then need to use a plunger or vacuum cleaner to suck out all of the brake fluid from the line connection point. Once all of the brake fluid has been removed, replace the connection point and reattach the hood.
Procedure
To flush the brake system in a Dot Brake car, follow these steps:
1. Park the car in a safe location.
2. Turn off the engine and remove the key from the ignition.
3. Open the trunk and remove any objects that may block your view of the brake system.
4. Place a bucket underneath one of the rear wheels. This will help to drain any fluid that accumulates in the braking system.
5. Disconnect all of the hoses from the brake fluid reservoir (or master cylinder if your car has one). Make sure that you disconnect both ends of every hose!
6. Pour approximately 2 cups of brake fluid into the bucket. Use caution not to spill any liquid onto yourself or your car!
7. Close all of the hoses and replace them on their respective fittings. Reinstall the key in the ignition and turn on the engine.
Benefits of Flushing Brake System
If your car has a DOT brake fluid, it’s important to flush the system every 3-5 years, as required by Federal law. Flushing the system helps to remove old brake dust, debris, and other liquids that can collect and cause problems.
There are several benefits of flushing the brake system. First, it helps to remove old brake dust and debris. This dust can reduce the effectiveness of your brakes and can lead to braking problems. Second, flushing the system removes any liquids that may have collected over time. These liquids can cause problems with your brakes if they stay in the system too long. Finally, flushing the system keeps your brakes Working In Good Condition (WIC) by removing any accumulated fluid that may be causing problems.
If you’re not sure whether your car requires a brake fluid flush, or how often to do it, please contact your mechanic. They will be able to help you determine when and how to flush your brake system.
Conclusion
If your car has a DOT 5 brake system, you may have noticed that the brakes stop working properly when the fluid level in the system gets low. Here is how to flush and refill the brake system: