If your gl1100I is having issues stopping on a hill, or if the ABS light is on and the brake pedal feels soft, it may be time to flush and replace the front brake system. This article will walk you through the necessary steps to do this.
Description of the Gl1100I
If you have a Gl1100I motorcycle, it is important to periodically flush the front brake system to keep it functioning properly.
To flush the brake system, follow these steps:
1. Park your bike on a level surface.
2. Remove the battery and turn off the ignition.
3. Disconnect the positive battery cable.
4. Open the right front wheel well cover by pressing down on the two tabs located on either side of the opening and pulling it towards you. The cover should swing forward out of the way.
5. Look inside the front wheel well and locate the brake fluid reservoir (or lines if there is no reservoir) . The reservoir may be partially or fully filled with brake fluid. If it is full, add more fluid until the reservoir is at least one-third full (see photo below). Replace the wheel well cover and tighten its screws.
6. Connect the negative battery cable and turn on the ignition.
7. Ride your bike as normal and use your brakes when necessary. Flush the system every time you stop to avoid getting brake dust in your engine oil!
How to Flush the Front Brake System
To flush the front brake system, follow these steps:
1. Park the car in a safe location.
2. Turn off both the ignition and the vehicle’s power steering.
3. Open the driver’s door.
4. Close the door gently, so that the handle doesn’t hit anything.
5. Press and hold down the emergency brake pedal while turning the wheel to the left (as viewed from inside the car). This will release the parking brake.
6. Keep your foot on the emergency brake pedal as you slowly turn the wheel to the right, so that all of the fluid goes out of the lines going to and from the brakes.
7. When all of the fluid has been drained, release the emergency brake pedal and close the driver’s door.
Troubleshooting the Gl1100I
If you are having trouble braking your motorcycle, it is likely that the front brake system is gluing together. This can be caused by a number of things, including water getting into the brakes or an issue with the front brake fluid.
To fix this problem, you will first need to determine what is causing the glueing. Then, you will need to flush the brakes and replace any damaged components. Finally, you will need to adjust the brake system to ensure that it works correctly.
Here are some tips on how to troubleshoot and repair the Gl1100I front brake system:
1. Check the Brake Fluid Level
One of the first things you should do when diagnosing a problem with your front brake system is to check the level of brake fluid. If the fluid is low or empty, this can cause the brakes to glue together. You can check the level of brake fluid by checking the reservoir or bottle inside of the bike.
2. Clean and Lubricate All Components
If there is water getting into your brakes, it is important to clean them and lubricate all of their components. This includes the caliper pistons, rotor, brackets, and hoses.