Air in your power steering system can cause poor performance and lead to costly repairs. In this article, we’ll show you how to get rid of air from your power steering system and improve your vehicle’s performance.
Power Steering fluid
If your car or truck is losing power steering fluid, you’ll need to take it in for a service. Here’s how to get air out of power steering fluid:
1. Remove the Torx screws on the side of the reservoir. Do not remove the cap.
2. Push the reservoir down and release the pressure inside.
3. Inspect the seal around the top of the reservoir. If it is broken, replace the reservoir. If the seal is intact, use a vacuum cleaner to remove any dirt or debris inside the reservoir.
4. Pour a small amount of fluid into a bottle and add enough water to make it seem like there is enough fluid in the reservoir.
5. Fill a bucket with water and place it over the open end of the reservoir. Turn on the vacuum cleaner and wait until the water starts to boil. Carefully pour the liquid from the reservoir into the bucket, avoiding getting any fluid in your eye or mouth.
How to remove air from power steering
If your car’s power steering is acting spongy or difficult to use, there might be air trapped in the system. Follow these steps to remove the air:
1] Turn off the car and disconnect the battery.
2] Remove the cover over the power steering fluid reservoir.
3] Use a turkey baster to suck out as much of the fluid as possible. Be sure to get all of the air bubbles out!
4] Replace the power steering fluid reservoir cover and connect the battery.
5] Drive your car until it is fully warmed up, then check for any air bubbles in the system. If there are any, repeat steps 3-5 until they are all gone.
Steps to follow when removing air from power steering
Step 1: Park the car in a safe location with the engine off.
Step 2: Disconnect the power steering hose from the pump.
Step 3: Open the power steering cooler reservoir and pour out any excess fluid.
Step 4: Inspect the power steering system for any debris or cobwebs that may have gotten into the system. Clear any obstructions if needed.
Step 5: Locate and remove the power steering pump cover. It is held on by two screws at each side.
Step 6: Remove the pump by unscrewing it from the mounting bracket. Be careful not to drop it!
Step 7: Inspect the impeller for damage and replace if necessary. Clean all components with a mild detergent and water. Allow to dry before re-installing.