If you’re experiencing difficulty steering your vehicle, it might be time to take a look at your power steering system. In this article, we’ll outline the basics of how power steering works, and outline some common problems that can cause steering to become difficult. We’ll also provide some tips on how to fix high pressure power steering hoses if they’re causing problems.
The Problem
If you notice a decrease in power when you apply the brakes, or if your steering feels shaky, there is a good chance that your high pressure power steering hose is at fault.
The high pressure power steering hose is responsible for delivering pressurized fluid to the hydraulic pump, which in turn provides the force necessary to steer the car. When this hose becomes damaged, it can cause a decrease in power and ultimately, a feeling of shakiness or instability when braking or turning.
There are several things that you can do to try and fix this problem on your own:
1. Check for any leaks – If there are any leaks present in the high pressure power steering system, this will allow PRESSURE to escape and cause damage to the hose. In order to check for leaks, you will need to remove the cover over the hydraulic pump and use a pressure gauge to measure the amount of PRESSURE being delivered to the wheels. If there is a significant drop in pressure, then you may have a leaky hose on your hands!
2. Replace the hose if it’s damaged – If your hose is already damaged, it’s best to replace it as soon as possible in order to avoid further
The Solution
If your car has a high pressure power steering hose, it may be time to fix it. This guide will show you how to do just that.
First, make sure the car is properly parked and the engine is off. Next, remove the battery cover. Underneath is a distributor cap and four bolts. Remove these and set them aside.
Next, remove the fuel pump relay fuse box cover. There are six screws holding it in place. Once removed, locate and remove the fuse box cover.
Locate the high pressure power steering hose near the wheel well on the passenger side. It should be connected to a metal bracket on the chassis. If it’s not, replace it with an identical part from a parts store or your car’s OEM supplier.
Next, use a wrench to loosen the hose clamp and then pull it off of the metal bracket. If there’s any debris or corrosion on the hose, use a brush or rag to clean it off before re-attaching it to the bracket.
Now tighten the hose clamp using a wrench. Make sure that it’s snug but not too tight – you don’t want to damage the hose
How To Do It Yourself
If you have a high pressure power steering hose that’s leaking, there are a few things you can do to fix it yourself. First, make sure the hose is properly tightened down. Second, check for any damage to the hose. And finally, replace the hose if necessary.