There are many things you need to know if you want to fix or replace something on your car, and one of them is how to remove a power steering pulley. This article will teach you how to do it, step by step, so that you can get your car back on the road as soon as possible.
What You’ll Need
In this article, we’ll show you how to remove and replace a power steering pulley on a Toyota Corolla. This is a common repair for Toyota drivers, so it’s important to have the right tools and know how to do it if something goes wrong.
Here’s what you’ll need:
-Screwdriver
-Lug wrench
-Tow truck
-Heavy object to hold pulley while screwdriver spins
-Pulley removal tool (optional)
First, make sure your car is in Park and the emergency brake is off. Next, use the lug wrench to loosen the bolt that holds the power steering pump in place. Remove the pump by unscrewing it from the bracket. Make sure you keep all of the parts, including the connector wires, in order. You’ll need them later.
Next, remove the five screws that hold the pulley in place using the screwdriver. Be careful not to lose any of these screws! Once they’re out, gently pull on the pulley until it comes off of the axle.
If you have a pulley removal tool available, use
How To Do It
When you need to replace a power steering pulley on a car, there are a few things you will need to do first. Check the fluid level, make sure the bolts are tight, and identify the correct pulley for your car.
If your car has an automatic transmission, you will also need to remove the gearshift assembly. Here’s how to do it:
1. Start by removing the four bolts that hold on the shift lever.
2. Next, disconnect the cable from the gearshift housing by undoing the two Torx screws at each end.
3. Carefully lift off the shift lever and set it aside.
4. Locate the power steering pump between the engine and transmissioncase and unscrew it using a 14mm socket and ratchet.
5. Remove the top cover of the pump by gently prying it off with a flathead screwdriver and then remove the impeller by unscrewing it with a 10mm wrench. Be very careful not to drop either of these items!
6. Place new power steering pulley onto frame of pump and secure with four bolts (two on each side). Tighten bolts to 91-
Tips for Success
When it comes to replacing a power steering pulley on a car, there are a few things you should keep in mind. Here are some tips to help make the process as smooth as possible:
1. Make sure you have the correct tools. You’ll need a torque wrench, drill bit, and straight edge to complete the job.
2. Plan your work in advance. This will help avoid any surprises during the replacement process.
3. Use caution when drilling into the car’s chassis. Take care not to damage the underlying structural components.
4. Follow the Pulley Replacement Guide provided by your car’s manufacturer for guidance on incorrect or difficult installation procedures.