If your car’s power steering is not working, you’ll need to replace the pump pulley. This is a relatively easy job that can be done by a DIYer or a mechanic. Here are step-by-step instructions on how to pull a power steering pump pulley.
What is a power steering pump pulley?
A power steering pump pulley is a part of the power steering system that helps to distribute the power from the engine to the pump. It’s typically made of metal and attaches to the pump’s shaft. When it starts to wear out, it can cause reduced power and difficulty steering. In some cases, it can also lead to sudden failure of the entire power steering system.
How do I pull a power steering pump pulley?
If you’re having trouble pulling your power steering pump pulley, there are a few things you can do to determine the cause. Inspecting your engine for signs of overheating or damaged insulation may give you a clue as to where the issue lies. And if that doesn’t help, trying removing and replacing individual pulleys one at a time may narrow down the problem.
Whatever the case, be patient and take your time; it might just take some trial and error to get your power steering back up and running smoothly.
Tips for pulling a power steering pump pulley
Power steering pump pulleys can be a challenge to remove, but there are a few tips that will make the task much easier.
1. Start by removing any obstacles that may be in the way. If the pulley is located behind a gear or differential assembly, remove those first.
2. Pry off the old seal and discard it.
3. Inspect the pulley for damage or rust and remove anything that is not necessary.
4. Place the new seal in place and screw it in place using an appropriately-sized screwdriver. Be sure to torque the seal down to specifications.
5. Coat the pulley with a light film of grease before installation and let it sit for at least an hour to allow the grease to spread evenly throughout the surface.
Conclusion
If your power steering pump pulley is starting to make loud noises, or isn’t working as it should, there are a few things you can do to address the issue. The first step is to determine if the pulley itself is the problem, and if not, you’ll need to address the belt. If neither of these solutions work, then your next step will be to pull the pump pulley. This guide will walk you through each of these steps so that you can get your power steering back up and running as quickly as possible.