If you’ve ever had to change your power steering belt, then you know that it can be a pain in the neck. But thanks to this handy guide, it should now be a lot easier for you to do it. This guide will teach you how to put on a power steering pulley, so be sure to give it a read if you’re ever in need of help!
What is a power steering pulley?
A power steering pulley is a device that is used to assist in the movement of a car’s power steering system. It is typically mounted to the car’s axle and provides input to the power steering system’s rack and pinion.
How to put on a power steering pulley
There are a few different ways to put on a power steering pulley, but the most common way is to use a universal joint. Before you start, make sure that your vehicle is properly inflated and the oil level is correct.
1. Park your vehicle on a level surface.
2. Remove the wheel and tire.
3. Remove the power steering pump cover by unscrewing four screws and lifting up.
4. Keep the screws as they will be needed later.
5. Use a Phillips screwdriver to remove the three bolts that hold the power steering pulley on (1). Note: The bolt in the middle of the power steering pulley might be hard to reach due to corrosion or dirt, in which case use a socket wrench or an extension cord to give you enough leverage.
6. Carefully pull the power steering pulley off of the shaft (2). If it doesn’t come off easily, use a socket wrench or an extension cord to turn it until it does. Be careful not to damage the shaft or pulley while you’re doing this.
7. Clean all of the grease and dust off of the power steering pump cover and pulley shaft with a solvent such as paint thinner
What are the benefits of putting on a power steering pulley?
A power steering pulley is a small, but important part of your car’s engine. It connects the power steering system to the car’s engine, and helps turn the wheels. Pulleys are made from different materials, and can have a range of different speeds.
There are a few benefits to putting on a power steering pulley. For one, it can improve the car’s handling. By connecting the power steering system to the car’s engine, you can make it more responsive. This means that you’ll be able to handle more turns in tight spaces, and will have better control over your car in general.
Another benefit of putting on a power steering pulley is that it can reduce wear on your car’s other components. By connecting the power steering system to the car’s engine, you’re reducing the amount of friction that exists between these two components. This can help to keep your car running smoother for longer, and reduce the chances of developing problems down the line.
How to remove a power steering pulley
If your car has a power steering pulley, it may need to be replaced. The pulley rotates the power steering pump, which helps to move the car. Here’s how to remove a power steering pulley:
1. Park your car on a level surface.
2. Raise and support the front of the car with a jack or other heavy object.
3. Remove the hood panel by prying at the edges and pulling upwards.
4. Disconnect the battery cable and remove the fuse panel cover.
5. Remove the two bolts that hold the power steering pump bracket in place.
6. Remove the power steering pump by unscrewing it from its mounting bolt.
7. Replace the power steering pump by bolting it onto the bracket and re-installing the bolts that were removed in step 5.
8. reconnect the battery cable and fuse panel cover, then return everything to its original position.
Conclusion
Putting on a power steering pulley can be a tricky task, but with the help of this guide, you should be able to get the job done no problem. Be sure to use the correct procedure for your car’s make and model and take note of any special instructions that come with your pulley. And lastly, don’t forget to wear protective gear when working with power steering components – especially if you’re not experienced in this type of work. Thanks for reading!