A power steering pulley is a component of a car’s powertrain that helps to distribute the power to the wheels. If your pulley is worn out or broken, it can cause your car to lose power and eventually stall. If you think your pulley may be defective, it’s important to replace it as soon as possible. Here are steps on how to do so.
Identification of the problem
If you are experiencing difficulty turning your car or the steering seems to be loose, it is likely that your power steering pulley needs to be replaced. This guide will walk you through the identification and replacement process for your car.
What To Look For
Before beginning any repairs, it is important to identify the problem. In order to do this, you will need to remove the front bumper cover. Underneath this cover, you will see four bolts that secure the power steering pump to the car. Once these bolts are removed, you can start inspecting the power steering system.
The first thing you will want to check is the power steering pump itself. Make sure that it is properly lubricated and that there are no cracks or leaks in its housing. If everything looks good, next step is to inspect the pulley itself. This is a rotating component that transmits power from the pump to the steering wheel. Make sure that it is free from any damage and that it is properly positioned on the shaft. If everything looks good, you can move on to replacing the pulley.
How To Replace A Power Steering Pulley
1 Remove front bumper cover
2 Locate four bolts securing power steering pump
Removal of the power steering pulley
Removal of the power steering pulley is a simple process that can be completed in a few minutes. The pulley is attached to the wheel by a number of bolts and can be removed without needing to remove the wheel.
1. Locate the power steering fluid reservoir. It should be located near the front of the vehicle on either side of the engine bay.
2. Open the cap of the reservoir and pour out any existing fluid. Make sure to follow the manufacturer’s instructions for returning fluid to its proper level.
3. Locate the power steering belt tensioner and pulley bolt. These are usually located behind or to one side of the belt tensioner, although they may be hidden behind other components.
4. Loosen both bolts and remove the pulley from the wheel. Be careful not to lose any screws or bolts as you remove it.
5. Reverse these steps to install the new pulley. Be sure to replace all screws and bolts as you attach it to the wheel
Installation of a new power steering pulley
When your power steering system starts to fail, there’s only one solution: replace the pulley. Here’s how to do it.
The first thing you’ll need is a new pulley. Depending on the make and model of your vehicle, you may be able to find a replacement at your local parts store or dealership. Once you’ve acquired the new pulley, take it to your car for installation.
To install the pulley, first remove the old one by removing the screws that hold it in place. Then, carefully pry up the old pulley with a flathead screwdriver until it comes free from the hub. Be careful not to damage the shaft or bearings along the way.
Next, put the new pulley on the hub and re-install the screws. Make sure that the bearing surfaces are lined up properly before tightening them down. Finally, reinstall the shroud and taillight assembly.
Conclusion
If you’re experiencing problems with your power steering, it might be time to replace your pulley. Replacing the pulley is a relatively easy and affordable fix that should improve your vehicle’s performance considerably. Here are some tips on how to do it: