When it comes to repairing and maintaining your car, there are a few things that you need to know. One of these is how to replace a power steering belt. This guide will show you how to do it on a 2000 Nissan Maxima.
Requirements
To replace a power steering belt on a Nissan Maxima, you will need the following:
-A Nissan Maxima belt kit
-A 3/8″ drive ratchet
-A 13mm socket
-A jack
-A chisel or a rebar tool
-A torque wrench
-Pliers
-Wire cutters
– lubricant (such as WD40)
Tools Needed
1. To do a power steering belt replacement on a Nissan Maxima, you will need the following tools:
a. Power steering belt tensioner
b. Torque wrench
c. 17 mm socket
d. Hammer
e. Nutdriver
f. Ratchet and extension cord
g. Flashlight
h. Jumper cables
2. Disconnect the negative battery cable before beginning work.
3. Remove the wheel and tire. Next, remove the four bolts that hold the power steering pump cover in place (2 per side). Once these bolts are removed, lift the power steering pump cover away from the engine bay. Underneath the power steering pump cover will be two hoses and a bracket; these items will need to be removed for installation of the new belt later on.
4. Remove the four bolts that hold the rack to the engine bay (2 per side). The rack can now be lifted out of the way, revealing the power steering pulley and fan assembly (see photo). The fan and pulley can now be accessed for removal and replacement of the belt (see photo). Be sure to note which direction rotation occurs on these parts –
Removal Procedure
To replace the power steering belt on a Nissan Maxima, follow the following steps:
1. Raise the hood of the vehicle.
2. Remove the three screws that secure the power steering pump cover to the engine block.
3. Remove the power steering pump cover.
4. Disconnect the power steering hose from the pump.
5. Remove the power steering belt by undoing the three fasteners it is attached to (two at the center of the belt and one at each end). Be careful not to damage the belt or pulley.
6. Replace the power steering belt and reattach the hose and fasteners in reverse order. torqe should be checked after installation to ensure that it is properly tightened
Installation Procedure
1. To replace the power steering belt on a Nissan Maxima, start by removing the steering wheel and console.
2. Next, unplug the power steering pump and disconnect the hose from the water pump.
3. Remove the power steering reservoir cover by unscrewing it from the front of the car.
4. Remove the power steering belt by undoing the two screws at either end. Make sure that the belt is properly tensioned before replacing it.
5. Replace the power steering reservoir cover, plug in the power steering pump, and reconnect the hose from the water pump.
6. Reconnect all of the cables and screw everything back together, ending with a tightened screw on the power steering reservoir cover.
7. reinstall the wheel and console and torque any necessary screws to manufacturers specifications.
Testing the Belt
If you are a Nissan Maxima owner and your power steering belt has failed, it is important to test the belt before you replace it. To do this, you will need to turn the wheel from the left to the right a few times. If the wheel moves freely, the belt is probably okay and can be replaced without issue. If the wheel does not move freely, then the belt needs to be replaced.
Conclusion
If your 2000 Nissan Maxima is experiencing problems with its power steering, it may be time to replace the belt. In this article, we will teach you how to replace the power steering belt on a 2000 Nissan Maxima. Make sure to read through all of the instructions before beginning so that you have a better understanding of what needs to be done. If you are unsure about any steps, please ask a friend or family member for help before starting. Enjoy!