If you’re ever in a situation where you need to jack up a car on soft ground, there’s a few things you’ll want to keep in mind. First of all, make sure the car is level so that the jacking beam is perpendicular to the ground. Second, be careful not to damage the underside of the car – if it’s too bent or crushed, it could prevent the jacking beam from extending far enough under the vehicle. And finally, use the required amount of force to get the jack up as high as possible – over-powering the jack could cause it to break or fail.
How To Jack Up A Car On Soft Ground
If you’re looking to jack up a car on soft ground, there are a few things you need to know. First, make sure the surface is level. Place the jack in the center of the wheel well and use your body weight to push down on the jack handle until it snaps into place. Second, be sure to use a lot of pressure when jacking up the car. Doing so will ensure that the car doesn’t move and that the bolts attaching the jack to the ground are tight. And finally, be careful not to damage your car or yourself!
Make Sure Your Jack Is The Right Size
When you’re ready to jack up your car, make sure the jack you choose is the right size. A large jack can damage your car’s suspension, while a small jack won’t be able to provide enough lift.
To find out the correct size for your jack, measure the height of the car’s lowest point with a tape measure. Then, use that measurement to find the corresponding jack size on our website or in our catalog.
If you have questions about how to jack up a car, give us a call at 1-800-4-JACKS. We’re happy to help!
Check The Jack Points
If you’re planning to jack up a car on soft ground, make sure to check the Jack Points. These are the points at which the vehicle’s suspension system is designed to support the weight of the car.
If you don’t check these points, your car could end up with major damage. Make sure to consult your car’s owner’s manual or take a look at this map to find out where the Jack Points are located on your specific vehicle.
Happy jacking!
Tighten the Bolts
There are a few different ways to jack up a car on soft ground. The first is to use a block and tackle system, which can be set up in a number of ways. The second is to use a motorized Jackup System, which can be rented or purchased. The third is to use a truckmounted Jackup System.
The block and tackle system is the simplest option and can be set up in minutes. It consists of two ropes, one attached to the car and one attached to a large block. To raise the car, the ropes are pulled in opposite directions.
The motorized Jackup System is faster and easier than the block and tackle system but requires more space. It consists of a truck mounted with an electric motor that raises and lowers the vehicle.
The truckmounted Jackup System is the most expensive option but also the fastest. It requires no setup time and can be used right away.
Final Check
If you are jack-raising a car on soft ground, it is important to make sure that the car is secure before you begin. First, use a ratchet strap to secure the front and rear of the car to prevent it from moving. Second, use a jack to lift the car off of the ground as evenly as possible. Finally, be careful not to over-torque the jack or your car.