If you’re like most people, you probably just pull your car up to the curb when you’re done parking. But what if there was a way to get your car up high so that it’s out of the way and you can easily load your groceries into the trunk? In this article, we’ll show you how to jack a car up high using simple tools and techniques.
What You’ll Need
In order to jack a car up high, you’ll need the following:
-A sturdy ladder
-A car jack
-A large flat space to park the car
-An old towel or piece of fabric to protect the paintwork
Step One: Locate a sturdy ladder. If available, use a sturdy one so it doesn’t move around when you’re jacking up the car.
Step Two: Park your car in a flat space and make sure there’s room for the ladder beneath it.
Step Three: Place the car jack on the ground next to the ladder and position the towel or fabric over the car’s roof.
Step Four: Lift up the ladder and place it against the side of the car.
Step Five: Slowly lower the jack until it touches the ground and then lift up again. The car should now be raised off of the ground.
How To Jack A Car Up High
Looking to jack a car up high? Check out our guide below.
If you’ve ever wanted to get a car up high, there are a few things you’ll need before hand. The most important tool is a jacking hammer, which can be found for around $15. Once you have that, all of the other tools and materials needed are relatively easy to come by.
The first step is to get the car off the ground. This can be done by using the jackhammer to break the car’s suspension or by using brute force and lifting the vehicle with your own two hands. It’s important to note that jacking a car up high can be very dangerous, so make sure you’re doing it in a safe area.
Once the car is off the ground, you’ll need to place it on some sturdy supports. We recommend using metal pipe poles or wood boards. Make sure that the supports are big enough so that the car doesn’t move and so that it’s easy to reach the undercarriage. Next, use your jacking hammer to start pounding on the undercarriage of the car. This will help loosen any bolts or screws that are holding it down.
Tips For Success
If you want to jack up a car high enough so that the wheel is off the ground and the car is resting on its suspension, there are a few things you will need to do.
First, make sure that the car is securely parked on a level surface. If it is not, you may end up damaging the car or yourself. Second, you will need to locate the suspension mounts. These can be found on either side of the car in front of the wheel wells. Third, use a sturdy stick to pry up on either side of the mount until it pops out. Fourth, use a jack to lift up the car and place the jack stands underneath. Fifth, carefully lower the car onto the jack stands and remove the jack. Sixth, repeat steps four through five for the other side.
Be careful when working with a car! It’s easy to damage either yourself or the car if done incorrectly.