If your car wouldn’t start after you tried to turn it over, but the engine was turning over just fine, chances are you have a crankshaft sensor failure. If this is the case, you’ll need to replace the crankshaft sensor. This article provides instructions on how to replace the crankshaft sensor on a 2004 Sebring.
What is a Crankshaft Sensor?
A crankshaft sensor is a device that monitors the position of the crankshaft in the engine. It helps to keep the car from starting on Sebring.
If the crankshaft sensor detects that the crankshaft is not rotating correctly, it will send a signal to the engine controller to stop the engine. This helps to prevent damage to the engine and keeps the car from starting.
How Does a Crankshaft Sensor Work?
1. A crankshaft sensor is a device that helps the engine to start. It is located on the crankshaft and sends a signal to the engine control unit (ECU) when it is time to start the engine.
2. The crankshaft sensor monitors the amount of oil pressure in the engine. If there is too little oil pressure, the ECU will not be able to start the engine. If there is too much oil pressure, the ECU will not be able to stop the engine from starting too quickly.
3. A crankshaft sensor can sometimes fail. If this happens, the ECU will not be able to start or stop the engine properly. This could lead to a car that won’t start or worse yet, could cause a car crash.
What to do if Your Car Won’t Start Because of a Crankshaft Sensor?
If your car won’t start because of a crankshaft sensor, there are several things that you can do to try and fix the problem.
First, check the battery charge. If the battery is fully charged, the car may not start because of a problem with the crankshaft sensor.
Second, check the fluid levels in the engine. Make sure that there is enough oil and coolant circulating through the engine. If there isn’t enough fluid, the crankshaft sensor may be malfunction.
If neither of these solutions works, then you may have to replace the crankshaft sensor. Depending on the type of car, this may cost between $200 and $1,000.
Conclusion
A car’s crankshaft sensor may not be the most exciting or well-known part of the engine, but it is essential in preventing engine failure. If your 2004 Sebring does not start when you try to turn the key, it is likely that your crankshaft sensor has gone bad. This part is relatively easy to replace and can be done in just a few minutes by a qualified mechanic. If you notice any other unusual symptoms with your car, like an issue with the ignition system or strange noises coming from under the hood, think about having your crankshaft sensor replaced as soon as possible.