If you have a Prius and are looking for a way to easily get your car jack ready for use, the following instructions will help. First, locate the jack handle on the driver’s side of your car. Once you have located it, use the provided instructions to fit the jack handle onto the car’s key fob. After you have fitted the jack handle, be sure to turn it to the “Lock” position so that thieves cannot steal it while you’re not using it.
Materials you will need
You will need the following materials to assemble your car jack prius:
-A 2 × 4
-A screwdriver
-A drill
-A Phillips screwdriver
-8 bolts (Locking type)
-1 washer
-1 nut
-3 nuts
-Tape measure
-Cordless drill/screwdriver
-Hammer
-Sticker
The steps to assembling your car jack prius are as follows:
1. Use the 2 × 4 to support the car jack. Place it in the center of the work area.
2. Drill a hole through the center of the wood support and screw it into the ground. This will serve as your car jack’s base.
3. Remove the screw from the base and replace it with a bolt that is slightly longer than the bolt that came with your car jack. This will act as a lock for your car jack, preventing it from moving during use.
4. Mark the locations of each bolt on both sides of the 2 × 4 using a pencil. Then, use a Phillips screwdriver to remove each bolt from its respective location and place them on the marked surface. Make sure each
Instructions
To assemble your car jack prius, follow the instructions that come with it. The jack prius is easy to use and should take about 20 minutes to assemble.
The first thing you will need is the jack prius. This is a piece of equipment that will help you lift your car.
Next, you will need the keychain remote control. This remote control allows you to operate the jack prius from a distance.
To assemble the jack prius, start by inserting the legs into the bottom of the handle. Then, place the top of the handle on top of the legs and push down until it clicks into place.
Now, attach the arm to the handle by grasping one end and pulling it towards you. Finally, connect the other end of the arm to the foot pedal.
Conclusion
If you’re looking for a step-by-step guide on how to assemble your Car Jack Prius 2016, look no further! In this article, we will walk you through the entire process from start to finish. Whether you are a first-time car owner or an experienced mechanic, I think you’ll find this guide useful. So be sure to check it out!