We all know one of the most important things in our cars is the ignition switch. It’s responsible for starting the engine and is a crucial part of our safety. But what happens when it gets dirty? In this article, we will show you how to clean car ignition switches and keep them running smoothly. From removing dirt and grease to fixing stalled startups, we’ll cover everything you need to know to keep your car in good working order.
What You’ll Need
To clean a car ignition switch, you’ll need:
-A can of compressed air
-A shop rag
-A wire brush
-Hole saw or jigsaw
-Phillips head screwdriver
-Ruler or straight edge
-Tape measure
-Lemon
1. Open the car’s hood and remove the engine cover. Look for the ignition switch on the left side of the engine.
2. Remove the screws that hold the switch in place. Carefully pull off the old switch and discard it.
3. Clean both sides of the new switch with compressed air and a shop rag. You can also use a wire brush to scrub off any dirt or grime.
4. Insert the screws and reattach the switch to the engine cover using a Phillips head screwdriver. Make sure that it’ssecurely attached by tightening up the screws.
5. Measure and mark where each ofthe screws goes on each side ofthe switchcover, then use a ruler or straight edge to make precise cuts. Make sure that your cuts are even all around,then remove the excess plastic with a pair of pliers (see photo below).
How to Do It
If you’re like most drivers, your car ignition switch is a dirty mess. The key fob doesn’t work, the engine won’t start, and worst of all, the switch could be causing expensive problems down the road.
Here’s how to clean your car ignition switch:
1) Park your car in a location where you can easily access all of the wires leading to the switch.
2) Turn off all of the lights in your car and use a battery-powered flashlight to locate each wire leading to the switch.
3) Disconnect each wire from the switch and place them on a clean surface.
4) Use a cleaner and a towel to apply pressure to the wires while cleaning them with a brush or cloth.
5) Once all of the dirt and debris are removed, reconnect each wire to the switch and turn on all of the lights in your car.
Tips for a Successful Cleaning
There are a few things that you can do to make cleaning the car ignition switch easier:
1. Make a checklist before you start. This will help you keep track of what needs to be done and make sure that you don’t skip anything.
2. Use a degreaser or cleaner specifically designed for ignition switches. These items are available at most automotive stores.
3. Be patient and thorough with your cleaning process. If the switch is dirty, it will take more than just soap and water to clean it properly.
Conclusion
If you’ve ever had to clean an ignition switch, then you know it can be a hassle. The oil and dirt that builds up over time makes the switch difficult to keep clean, and it’s often not easy to get at without damaging it in the process. In this article, we will show you how to clean an ignition switch using simple supplies that you likely have on hand. By following these steps, you should be able to keep your ignition switch in excellent condition for years to come.