For most of us, getting our car started is a pretty simple process. We flip the switch and voilà—the engine starts. However, for those of us who have lost or forgotten our car keys, there’s another way to get your car running: by wiring it in. This guide will show you how to do just that, so you can drive your vehicle without any hassle. When wiring a car ignition switch, be sure to follow these simple steps so you don’t end up damaging your vehicle or yourself in the process.
What You’ll Need
What You’ll Need:
– Ignition switch wiring diagram
– 12VDC battery (or other power source)
– Wire strippers and crimpers
– Soldering iron and solder
– Wire nuts and screws
– Jumper cables (at least two sets)
– Car kit with wires matching the color of your car’s wires. For example, Ford uses red and white wire for their cars.
Step 1: Locate the ignition switch in your vehicle. On most vehicles, this is located on the dashboard near the steering wheel. If you aren’t sure where it is, you can check by looking at your car’s owners manual or online. Once you’ve located it, remove the cover with a screwdriver.
Step 2: Locate the positive (+) wire connected to the ignition switch and cut off about 6 inches of the wire. Strip 1/4 inch of insulation from each end of the wire, then twist each end into a small loop. This will be our ground wire.
Step 3: Locate the negative (-) wire connected to the ignition switch and cut off about 6 inches of the wire. Strip 1/4 inch of insulation
How to Wire a Car Ignition Switch
If you have a car with an electronic ignition, there is a good chance that the switch is digital. In this article, we will show you how to wire a car ignition switch using a voltmeter and some simple electrical connectors.
1. Start by removing the cover of the switch. On most models, this is simply done by twisting it counter-clockwise until it pops off. Be careful not to lose any screws or other pieces while doing this!
2. Once the cover is off, you will see three wires going into the switch. The black (hot), red (ignition) and green (neutral) wires should all be connected to corresponding terminals on your voltmeter. If they’re not, then you will need to make some connections yourself.
3. To do this, take the black wire and connect it to terminal 2 on your voltmeter. Take the red wire and connect it to terminal 1 on your voltmeter. Take the green wire and connect it to terminal 3 on your voltmeter…
4…and that’s it! You now have a working car ignition switch wired correctly!
Tips for Wiring a Car Ignition Switch
If you have a car with a traditional key switch, or if you’re retrofitting an older car with a key switch, follow these simple tips to wiring your ignition switch:
1. Center the black and brown wires of your key ring connector in the appropriate holes on the switch. Don’t twist the wires together yet.
2. Twist the wires together until they are tight, but not too tight.
3. Push the connector all the way into the switch’s housing. Make sure it’s secure by wiggling it around a little bit.
4. Test your connection by turning on your car and pressing the button on your key ring connector. The engine should start right up.
Conclusion
Wiring a car ignition switch can be a tricky task, but with the help of this guide, it should be much easier for you to get the job done. By following the instructions provided, you will be able to install your new switch in no time and fix any issues that might have come up along the way. If you ever have questions about how to wire a car ignition switch or need help finding the right part for your vehicle, feel free to contact us at anytime. We would be happy to help!