One of the more common tasks parents face is removing the back of a car seat. Whether to wash it or change the baby’s diaper, removing the back of a car seat is an essential task. Luckily, it’s not difficult and can be done in just a few minutes. Here are four tips for removing the back of a Graco car seat: 1) Place the car seat in a position that will make it easiest to access the straps. If you have a base that has a removable back, place the base in this position. 2) Unbuckle all the straps and remove them from the vehicle. This will minimize movement while you’re working. 3) If your car has a headrest adjuster, use it to raise or lower the headrest so you have more space to work. 4) Pull down on one side of the belt clip until it unhooks from the belt and then remove it. Repeat on the other side. Once all of the straps are removed, you can start to untie the loops at either end of the belt. Do this one at a time so you don’t create any knots. Once both ends of the
Materials needed
Materials Needed:
– Graco car seat
– Teflon tape
– Razor blade
– Glue gun
– Hammer
– Nail (optional)
1. Remove the back of your Graco car seat by following these simple steps: a. Remove the screws that secure the back portion of the car seat to the base. b. Lift up on the back of the car seat and remove it. c. Use a razor blade to cut away any fabric or padding surrounding the safety strap system, then remove that as well. d. Pry up any adhesive residue with a glue gun, then use a hammer to gently tap off any extra pieces of glue. e. Wash all components in hot water and mild detergent before reinstalling them in your carseat according to manufacturer’s instructions.
Instructions
Step 1: Remove the two top screws on the back of your Graco car seat.
Step 2: Gently pull the back off of your car seat.
Step 3: Disconnect the straps from the front and back of the car seat.
Step 4: There are two clips at each end of the back that you will need to remove before you can remove it completely from your car.
Step 5: Throw away the old fabric cover and replace it with a new one if you prefer. We recommend using a water-resistant cover for added protection in case of rain or accidents.
Your Graco car seat is now ready for use!
Tips for success
Remove the back of a Graco car seat by following these easy tips:
1. Locate the two clips that secure the back of the car seat to the base. There are likely two small holes in each clip.
2. Insert a thin object, like a fishing rod, between the back of the car seat and the base and twist gently until both clips release.
3. Remove the back of the car seat by pulling it off of the base.