If you’re looking to fix your car, or just want to learn more about it, a broken ac evaporator temp sensor is one of the most common problems that you’ll encounter. In this article, we’ll show you how to find and replace the ac evaporator temp sensor on a 2005 Lincoln Town Car.
What is an evaporator temp sensor?
An evaporator temp sensor is a device that monitors the temperature of the evaporator coil in an air conditioner. It is located on the outside of the condenser unit.
2. Why is it important to keep the evaporator temp sensor clean?
If the evaporator temp sensor is not kept clean, it can result in degraded cooling performance and shortened compressor life. Cleaning the evaporator temp sensor helps to maintain optimal cooling and system efficiency.
Location of evaporator temp sensor on 2005 Lincoln Town Car
If you have a 2005 Lincoln Town Car, the evaporator temp sensor is located on the lower right side of the engine. The part number for this sensor is 5W4Z-1349-A.
How to change evaporator temp sensor on 2005 Lincoln Town Car?
If you are experiencing problems with your 2005 Lincoln Town Car’s AC evaporator, it may be time to replace the temp sensor. This is a simple repair that can save you a lot of money in the long run. Here’s how to change the evaporator temp sensor on a 2005 Lincoln Town Car:
1. Park your car in a warm environment so that the AC is on full blast.
2. Disable the car’s security system by pressing and holding the lever near the gearshift until the warning light goes off.
3. Open the hood and locate the evaporator ducts. You will see two white plastic clips near one of the ducts. Push down on these clips and then pull out the duct until it snaps into place.
4. Disconnect thetemp sensor from its wiring harness by gently pulling it away from its housing. The sensor has two black wires, one red wire, and one green wire.
5. Strip about 1/2 inch off each end of each wire using a pair of pliers. Twist each wire together several times, then attach them to the new temp sensor by wrapping them around the sensor’s metal base once again.
6. Replace the duct assembly and secure it