It’s one thing to be stranded on the side of the road – it’s another to have your car die when you need it the most. In this article, we’ll explore what can happen when you put your car in gear and how to prevent it from happening.
When to Check Engine Light
A car’s engine will run and idle correctly when it is cold, but may not start when the car is hot. This is because the engine oil has a thick sludge layer at cold temperatures that forms lumps on the pistons and rings. The heat of the engine crushes these lumps, breaking down the oil into a fine mist that flows freely through the engine.
When your car’s engine starts, you should check its Check Engine Light (CEL) to make sure there are no problems with its oil system. A CEL indicates there may be a problem with your car’s oil or air filter. If your CEL comes on soon after you turn the car on, your air filter is likely dirty and needs to be replaced.
If your CEL comes on after you’ve been driving for a while, there may be an issue with your car’s oil system. To check if your car has an oil issue, drive it until it stalls and then have a friend pull over next to you so you can see if their car stalls too. If yours does, there may be an issue with your oil system.
Causes of a Dead Battery
Your car battery may die when you put it in gear, or when the car is turned off. Here are some of the most common causes:
-A bad alternator -This is the device that charges your car battery. If it’s weak or worn out, it won’t be able to provide enough power to your battery, and it’ll start to die.
-A bad voltage regulator -This is a part of your car’s electrical system. If it’s malfunctioning, the voltage coming from the battery can be too high for the parts in your car that need it, like your headlights and stereo. This can kill your battery.
-Low oil levels -If your engine isn’t getting enough oil, it can prevent the pistons from turning properly and causing problems with the ignition system. This can also lead to low fuel levels in your car’s engine, which will eventually kill your battery.
How to Fix a Dead Battery
If your car will not start, chances are the battery is dead. Here are some steps to try to fix a dead battery:
1. If your car has a manual transmission, shift into Park and turn off the engine.
2. Remove the key from the ignition and remove the battery cable.
3. Open the hood and disconnect the negative cable from the battery.
4. Use a voltmeter to measure the voltage at each terminal of the battery. The reading should be at least 12 volts. If it’s not, you will need to replace the battery.
5. reattach the positive cable to the battery and connect it to the positive terminal on the engine block or on an electric box connected to the engine block.
6. Turn on the engine and check for voltage at each terminal of the battery again. The reading should be 12 volts or higher now.
Jumpstarting a Car
If your car has stalled, there are a few things you can try before calling a tow truck. Jumpstarting the car is one of the simplest, most reliable methods. Here’s how to do it:
1) Park the car in a safe location with the engine off.
2) Remove the battery if possible and unplug any cables that are connected to it.
3) Open the hood and locate the Starter motor. It will be near the driveshaft.
4) Position yourself behind the car and hold onto the starter motor while turning the key all the way to start.
5) When you hear a loud clicking sound, release the starter motor and push it all the way into the engine.
6) Turn on the car’s engine by turning the key all of the way to “ON.”
Conclusion
If you’re experiencing this problem with your car, it might be time to take it in for a mechanic. Your car’s transmission might not be able to handle the sudden change in speed when you put the gear into drive. A mechanic can diagnose and fix the issue quickly, so don’t hesitate to bring your car in for a check-up.