If you’re having trouble turning your 2012 Ford Fusion in a straight line, it might be time to get a power steering pump replaced. According to the NHTSA, between January 1 and December 31 of this year, Ford reported an increase of approximately 36 percent in power steering pump failures. While the exact cause of these failures is still unknown, it’s important to be aware of the issue so that you can take preventative steps.
What is a power steering pump?
A power steering pump is a device that helps to turn the wheels of a car. It is located in the engine bay and uses oil to turn the gears.
Ford Fusion models have a power steering pump that can fail. If this pump fails, it can cause the car to become difficult to drive. In some cases, the car may also become stuck in first gear.
If you are experiencing any of these problems, it is important to get your car checked by a mechanic. A failure of the power steering pump can lead to dangerous driving conditions.
What to do if you think your Ford Fusion has a power steering pump problem
If you think your Ford Fusion has a power steering pump problem, the first thing you should do is take it to a mechanic. A power steering pump is an important part of the car’s system and if it’s not working properly, it can cause serious problems.
If you can’t get your Ford Fusion to start, the first thing you should do is check the fuel filter. If the filter is dirty or damaged, it can cause the car to not start. Next, check for any fluid leaks. If you see any fluid leaking from under the car, there may be a power steering pump problem. Finally, try turning the car’s key in both the ignition and on the driver’s side door (if applicable). If one of these things doesn’t work, then it likely means that there’s a power steering pump problem and you’ll need to take your Ford Fusion to a mechanic.
How to test if your Ford Fusion has a power steering pump problem
If you are having trouble steering your Ford Fusion, there is a good chance that the power steering pump is causing the problem. You can test to see if this is the case by following these steps:
1. Park your car in a safe location.
2. Turn off the ignition and all of the other electrical accessories in your car.
3. Remove the reservoir cap on the power steering pump.
4. Using a flashlight, check to see if the fluid level is low. If it is, replace the power steering pump.
How to replace a power steering pump in a 2012 Ford Fusion
If you are experiencing low power steering while driving, you may need to replace your power steering pump. Here are instructions on how to do this in a 2012 Ford Fusion.
1) Park the car in a safe location and turn off the engine.
2) Open the hood and remove the battery cover.
3) Underneath the hood, locate the power steering pump. It is located on the right side of the engine block.
4) Remove the power steering pump by unscrewing it from the shaft. Be sure to replace it with a new part if necessary.
5) Replace the power steering pump and Torx screwdriver connection with new parts, and close the hood.
6) Turn on the engine and check for leaks. If there are no leaks, you can drive the car. If there are leaks, have a mechanic come out and fix them.