Car ignition cables are one of those essential pieces of equipment that you only think about when they go wrong. But what if they don’t go wrong? What if they just stop working? In this blog post, we will take a look at what happens when your car’s ignition cables go bad and how to repair them. From basic removal and replacement to more complex repairs, we will walk you through each step. Whether your car has electronic keyless starting or not, you’ll want to know how to fix an ignition cable if it goes bad.
What are ignition cables?
If your car doesn’t start, you may need to check the ignition cables. These cables connect the spark plugs to the distributor, and can become worn or damaged over time. If one or more of these cables is broken, it will not create enough sparks to start the engine. In some cases, a broken cable can cause a “dead” engine.
How do they work?
There are two types of ignition cables: direct and secondary. Direct cables connect the spark plugs to the distributor. Secondary cables connect the distributor to the engine block.
The primary purpose of an ignition cable is to provide a path from the spark plugs to the distributor, which ignites the fuel in the cylinders. When you turn your key in your car’s ignition, electricity travels through these cables and into the spark plugs. This current then sets off a detonation reaction in each cylinder, which results in combustion and gas release.
When should I replace my ignition cables?
There is no set answer, as it depends on a variety of factors. However, generally speaking, ignition cables will last around 10,000 miles if they are maintained properly. If the car is not starting or has been running poorly, it may be time to replace the cables.
What are the dangers of not replacing your ignition cables?
If your car does not have new ignition cables, wear and tear over time can cause them to become brittle and break. A failed cable can cause the car’s engine to stall, making it difficult to start. If the failure is severe enough, the cable can pull off the spark plugs, causing a fire. In addition, if the airbag sensor is triggered as a result of a broken ignition cable, the resulting explosion could damage your vehicle or injure you. Finally, if water gets inside of an ignition cable while it’s operating, it can create sparks that could start a fire. If any of these events occurs, get your car serviced as soon as possible to prevent serious injuries or property damage.
Conclusion
If your car has an ignition, then it likely has cables that need to be replaced. Getting them done on time will prevent any problems from arising in the future and keep your car running smoothly. Follow our guide below to find out when your ignition cables should be replaced, what tools you’ll need, and how much it will cost.