If you’re like most people, you change your car’s thermostat at least once a year. But what do you do if the car’s thermostat goes bad? There are a few options, and each has its own set of pros and cons. In this article, we’ll discuss how to replace a car’s thermostat, and give you some tips on how to choose the right one for your vehicle.
What is a car thermostat?
A car thermostat is a device that regulates the temperature inside your car. It’s most commonly found on vehicles made in the 1980s and 1990s, but they can be found on newer cars as well. Car thermostats typically last around six years before they need to be replaced.
How does a car thermostat work?
A car thermostat is a device that controls the temperature inside a car. The thermostat works by sensing the difference in air temperature outside and the temperature inside the car. When the temperature inside the car is higher than the temperature outside, the thermostat will send a signal to the car’s engine to turn on the heat, and when the temperature inside is lower than the temperature outside, the thermostat will send a signal to the car’s engine to turn off the heat.
The average life expectancy of a car thermostat is around 10 years.
What are the different types of car thermostats?
There are many types of car thermostats, but the most common are the electronic and manual ones. Electronic thermostats use sensors to detect the temperature inside the car and then turn on or off the heating system accordingly. Manual thermostats use a knob to set the desired temperature, and they usually last longer than electronic ones.
How to replace a car thermostat
Replacing a car thermostat is an easy task that can be done in just a few minutes. Here are the steps:
1. Open the hood of your car and locate the cooling system.
2. Disconnect the old thermostat from the cooling system by unscrewing it.
3. Remove the old thermostat from your car by pulling it out.
4. Install the new thermostat by screwing it into place and securing it with the screws that were provided.
5. Connect the cooling system to the new thermostat and reattach the connector hose.
6. Close the hood of your car and turn on the ignition to test everything out.
How to lubricate a car thermostat
If your car’s thermostat is not working, there may be debris or mineral deposits that have built up on the heating element and need to be cleaned. Cleaning the thermostat is a simple process that can be done by anyone with a little common sense and access to a vacuum cleaner. Here’s how:
1) Disconnect the thermostat from the car’s system by disconnecting the black wire from the thermostat.
2) Open the hood of your car and locate the vacuuming hose. If you don’t have a vacuuming hose, you can purchase one at most convenience stores for about $10.
3) Locate the vacuum cleaner and turn it on. Make sure the hose is connected to the vacuum cleaner nozzle.
4) Position the nozzle over the top of the thermostat housing and press down firmly so that all of the dirt, dust, and debris is sucked up into the hose. Be sure to clean around all of the fins on top of the heating element as well.
5) After cleaning, replace the housing cover and reattach the black wire to the thermostat. Reconnect your car’s system.