Brake fluid and brake pads are two of the most important components in your Honda Pilot’s braking system. Over time, brake fluid can become contaminated with dirt, dust and other debris. When this happens, your Honda Pilot’s brakes will not work as well as they should – and this could be dangerous if you’re driving on the freeway.
What is a Full Brake Flush?
A full brake flush is a service that is performed on your Honda Pilot to remove all of the brake dust, grime, and debris that can accumulate over time. This service is essential to keep your brakes in top condition and prevent any potential issues down the road.
The Honda Pilot recommends that brake flushes be performed every 6 months or 12,000 miles, whichever comes first. The frequency of the flush will depend on how often you use your brakes and how dirty they become.
What to Expect During a Full Brake Flush:
During a full brake flush, our technicians will remove all of the accumulated dust, grime, and debris from your Honda Pilot’s brakes. This service is essential to keep them in top condition and prevent any potential issues down the road.
In addition to the brake flushes, we also recommend regular inspections for any signs of wear or tear on your car’s brakes. If you notice anything unusual or suspect that your brakes need attention, please don’t hesitate to call us for a free inspection!
How Often Should a Honda Pilot be Flushed?
If your Honda Pilot has an automatic transmission, it should be flushed with fluid every 7,500 miles; for a manual transmission, it should be flushed at 10,000 miles.
Why Is It Important to Flush the Brakes?
One of the most common questions asked by Honda Pilot owners is “why is it important to flush the brakes?” The answer is actually quite simple. Flushing the brakes ensures that the brake pads are properly cleaned and protected from rust and corrosion. By cleaning and lubricating the pads, you create a better surface for your brakes to engage with, preventing them from becoming worn and requiring replacement.
Methods of Flushing Honda Pilots
If you are experiencing brake issues on your Honda Pilot, there are a few different methods you can try to flush and fix the problem.
One of the most common ways to flush a Honda Pilot’s brake system is to do a full brake fluid flush. To do this, you will need to remove the master cylinder and fluid reservoir, bleed the brakes, refill the reservoir and reattach it, and bleed the brakes again. To ensure that all air is removed from the lines, you can also perform a purge procedure.
Conclusion
If you’re looking to do a full brake fluid flush on your Honda Pilot, here are the steps you need to take:
1. Park the car in a safe location and turn off all electrical accessories
2. Drain any excess oil or lubricant from the calipers, rotor, and brake lines using a suitable container or pump
3. Remove the wheel and drive axle from the vehicle
4. Disconnect each brake line at both calipers by depressing the clip into position with a screwdriver then pulling up on it while holding onto the line itself
5. Pour brake fluid down each line until it is nearly full then replace each clip and secure lines with screws