Brake fluid flushes are an important part of maintaining your vehicle’s braking system. Knowing when and how to do a brake fluid flush is important to keeping your brakes in good working order. Check out this article to learn more about when and how to do a brake flush!
What is a brake flush?
A brake flush is a service that is performed on your car’s brakes. It involves flushing the brake system with clean water to remove any debris and contaminants that may have built up over time. This service can help to improve the braking performance of your car.
Why do you need to do a brake flush?
A brake flush is typically done when you notice a decrease in brake performance. The most common symptom of a brake flush is that your car takes longer to stop from a stop. Brake flushes are also done when the brake pads or rotors are showing signs of wear.
How to do a brake flush
A brake flush is a great way to clean and condition your brakes. The procedure is simple and can be done by anyone with basic car repair skills. Here’s how to do it:
1) Remove the wheel and tire.
2) Locate the brake lines near the wheel.
3) Disconnect the lines at the caliper.
4) Remove the brake pads (if applicable).
5) Fill a bucket with tap water and pour it into the calipers.
6) Swirl the water around to dislodge any dirt, debris, or oil.
7) Allow the bucket to sit in the calipers for several minutes while you work on the brakes elsewhere on the car.
8) Remove the pad cup, then use a hose to wash all of the water out of the system.
9) Replace the pad cup, then reattach the brake lines to the caliper.
10) Replace the wheel and tire.
What to expect after doing a brake flush
If you’ve ever had to do a brake flush on your car, you know that it’s not an easy task. But, now that you know what to expect, it’ll be a breeze. Follow these steps to do the job right:
1. Remove the dust cover over the brake caliper (it just pops off).
2. Use a vacuum cleaner and clean all of the rust and debris off the brake pads and rotors. Make sure to wear gloves and avoid getting any of the fluid on your skin.
3. Pour brake fluid into each caliper (4 cups per caliper) until it is halfway full (don’t overfill!).
4. Shut off the engine and wait 10 minutes for the fluid to heat up before starting it back up.
5. Repeat steps 2-4 until all of the brake fluid has been replaced.