If you own a Hummer, then you know that it can be a challenging task to get your car jacked! Fortunately, there are a few easy steps you can take to make the process go smoothly. In this article, we’ll explain how to assemble and use a Hummer car jack, so that you can get your vehicle back on the road as quickly and safely as possible!
Why do you need a Hummer car jack?
A Hummer car jack is an important tool for anyone who owns or drives a Hummer. A Hummer car jack can be used to lift or lower your Hummer, and it can also be used to assist in loading or unloading your vehicle.
A Hummer car jack is also a great safety tool. If you ever have to break a window to get out of a sticky situation, a Hummer car jack can help you do it easily and without risking injury.
Finally, a Hummer car jack can also be used as a makeshift step ladder. If you need to reach something high up on your vehicle, installing a Hummer car jack will allow you to do so with ease.
How to assemble a Hummer car jack
If you’re looking to get a little more lift out of your Hummer, or just need an extra hand to help with larger tasks, you’ll want to add a car jack to your toolbox.
Here’s how to assemble one:
1. Open the hood of your Hummer and locate the four screws that hold the air intake in place. Remove these screws using a Phillips head screwdriver.
2. Once the screws are removed, lift the air intake off of the vehicle.
3. Locate the car jack assembly on the left side of the vehicle and remove it by unscrewing the two screws that hold it in place.
4. Slide the car jack onto the axle of your Hummer and tighten the screws that are located on each side of the jack.
The benefits of having a Hummer car jack
If you’re like most people, you probably only use your car’s standard jack when you need to change a tire. But if you own a Hummer, you need a Hummer car jack! Here are four reasons why:
1. A Hummer car jack is built to handle the weight of a H2.
2. A Hummer car jack is specially designed to support the vehicle evenly, so it doesn’t damage the finish on your car.
3. A Hummer car jack can be used to raise and lower your vehicle without having to get out of the driver’s seat.
4. A Hummer car jack is the perfect accessory for anyone who loves to customize their ride!
Conclusion
Assembling a Hummer car jack can be a little daunting, but with the right instructions and some patience, it shouldn’t be too difficult. Here are the steps you need to follow: 1. Locate the screws that hold the main arm on your truck to the body of your vehicle. 2. Remove these screws by unscrewing them counter-clockwise with a Phillips head screwdriver. 3. Now you’ll need to separate the arm from the body of your truck by sliding it towards you while pulling upward on both ends (this should release any clips that may have been holding it in place). 4. Next, take note of where each wire goes (it will look similar to a power cord) and cut each one approximately 2 feet long using a Knife or Wire Stripper (you might also want to remove any insulation if necessary). 5. Slide each wire into its respective hole on the arm, making sure not to pinch them together too tightly – they should now just barely fit into their slots. 6. Reconnect the clip that held the arm onto the truck body, then screw everything back together in reverse order – starting with step 1!