When it comes to car seats, many parents are faced with a difficult decision: which one is best for their child? And with so many different brands and models to choose from, how can you be sure you’re making the right choice? Here are some tips on how to assemble evenflo graco car seat. By following these simple steps, you’ll be able to put your child in the safest possible seat in no time at all.
Parts of the Seat
If you are assembling your Graco car seat yourself, be sure to read the following instructions carefully. First, make sure that all of the parts are clean and free of dirt or debris.
1) Open the restraint system cover by pressing down on one side and pulling up on the other.
2) Remove the four bolts (two on each side), then remove the restraint cover.
3) To install the shoulder belt positioning pad, insert one end into one of the two slots on the base, making sure it is lined up with the “Buckle” hole. Push down until it snaps into place. Repeat for other side.
4) Install two new screws in each corner of the positioning pad to hold it in place.
5) Place the restraint system cover back on top and secure with four bolts (two per side).
6) Reinstall restraint system cover retainer by gently pushing from behind and snapping into place.
7) Reconnect cord connector at bottom of restraint system cover retainer.
8 ) Replace padding by inserting foam piece into each side retainer and pushing together until it clicks into place.
9 ) Replace base by sliding it onto padding and securing with screws (three per side). Be sure to align holes in both sides before tightening screws!
Installation
Installing your Graco car seat can be a little tricky, but it’s really not that difficult. Here are the steps:
1. Open the car seat and remove the base.
2. Remove the fabric insert and safety straps.
3. Slide the frame over the child’s body and attach it to the base with the four screws provided.
4. Reattach the safety straps and fabric insert.
5. Close up the car seat by zipping up both sides of the fabric cover
Adjustments
If you have a Graco car seat and need to make adjustments, follow these steps:
1. Find the adjustment anchors on both the car seat and your child’s carrier. There are usually two or three in each area.
2. Click and pull gently on the adjustment anchors to move them into the positions you want. Be sure not to twist them or they may become stuck.
3. Tighten the anchor screws by hand, using a Phillips screwdriver if necessary, until they’re snug but not tight. Don’t over-tighten! Doing so can damage your car seat or your child’s carrier.
Safety Tips
Safety Tips for Assembling Your Evenflo Graco Car Seat:
1. Read the instructions carefully before starting to assemble your car seat. The evenflo car seat has many parts and can be difficult to put together if you don’t follow the directions closely.
2. Use clamps or bungee cords to secure the straps while assembling the car seat. This will help ensure that your child is safely secured in the seat during crashes.
3. Be sure to read and follow all safety warnings when assembling your car seat. This includes checking that all of the straps are tight, making sure there are no dangling pieces, and verifying that the car seat is properly installed in your vehicle.
4. If you have any questions about how to assemble your car seat or any safety concerns, please do not hesitate to contact customer service for help.
Conclusion
As a parent, it is important to be able to put together your child’s car seat in a snap. Evenflo has created an easy-to-follow instruction video that will have you putting together the car seat in no time at all. If you’re ever stuck on something and can’t seem to find the answer online, give their video a watch for some helpful tips.