If your Chevy Silverado is experiencing some difficulty with power steering, it might be time to change the fluid. Follow these steps to change the fluid in a Chevy Silverado:
Identification of Issue
If you’re noticing your Chevy Silverado is having difficulty turning, it might be time to change the power steering fluid. Here’s how to do it:
1. Park the car in a level area.
2. Turn off the engine and remove the key from the ignition.
3. Open the hood and locate the power steering reservoir. It’s typically located on the driver’s side near the front axle.
4. Remove the cap and pour out a quarter-inch or so of power steering fluid. Replace the cap and replace any lost fluid.
5. Start the engine and turn it off multiple times to allow the fluid to circulate through the system.
6. Check for leaks by placing a finger inside of each wheel well and feel for a damp spot. If there is one, fix it before continuing with step 7.
7. Add power steering fluid as needed until you achieve desired performance. Be sure to use manufacturer-recommended fluids, as overuse can damage your car’s components
Removal of Fluid
In order to change the power steering fluid in a Chevrolet Silverado, you will need to remove the front passenger side engine cover. Additionally, note that the power steering fluid reservoir and lines are located behind the engine cover, so you will also need to remove the engine cover to access them.
1.Remove the front passenger side engine cover (2).
2.Locate the power steering fluid reservoir and lines (3).
3.Remove the power steering fluid reservoir (4) and lines (5).
4.Clean all debris from the power steering system area (6).
5.Replace power steering fluid reservoir and lines (7).
Replacement of Fluid
If your Chevrolet Silverado is experiencing jerky or lack of power while driving, it might be time to change the power steering fluid. This guide will show you how to do it yourself, with just a few simple tools.
Replacing the power steering fluid is a routine maintenance procedure for most Chevrolet Silverado owners. When the fluid becomes contaminated, it can cause slippage and reduced power. The steps in this guide are straightforward and should take around 30 minutes to complete.
First, remove the front splash shield and front bumper cover. Then, loosen the steering linkage using a 15mm socket and wrench. Next, remove the power steering unit bolts with a 8mm socket and wrench. Finally, remove the power steering unit by pulling gently on it until it pops off! Once it’s removed, replace the old fluid with a new bottle of GM part number 85105677. Be sure to assemble all of the components before replacing them back in place.
Driving the Vehicle After Fluid Replacement
When your Chevy Silverado needs a power steering fluid change, you might be wondering how to get the job done. Here are some tips on how to change the power steering fluid on your Chevrolet Silverado:
1) Disconnect the negative battery cable.
2) Remove the air intake cover.
3) Remove the four bolts that hold the power steering pump cover in place.
4) Remove the power steering pump cover.
5) Check and fill the power steering fluid reservoir. (Chevy recommends using SAE 15W-30 oil.)
6) Replace the power steering pump cover and bolts.
7) Connect the negative battery cable and air intake cover.
8) Reinstall the stereo and instrument panel trim.
9) Reconnect the power steering fluid line to the pump. (See Chevy service manual for further instructions.)