Many car owners find that they need to change their power steering gear box at some point in their vehicle’s life. Whilst the process of changing the gear box is not always straightforward, there are a few simple steps you can take to make the task as easy as possible for yourself. With the help of this guide, you’ll be able to identify the parts of the gear box, understand how they work together, and figure out how to replace them without any trouble at all. So why wait? Start learning how to change your power steering gear box today!
The Different Types of Power Steering Gears
There are basically three types of power steering gear boxes in use today: Rack and Pinion, Direct Drive, and Power Shift.
Rack and Pinion: This type of gear box is the most common, and uses a set of gears inside the car to turn the axle. The disadvantage to this type of gear box is that it can be quite noisy, and it can also be difficult to change.
Direct Drive: This type of gear box uses a belt or chain to turn the axle, and it’s generally much quieter than a Rack and Pinion gear box. The main advantage to this type of gear box is that it’s easier to change, because you just have to unclip the belt or chain and replace it with a new one.
Power Shift: This type of gear box is unique because it doesn’t use gears at all – Instead, it uses a motorised transmission system to shift the gears. This system is usually more expensive than other types of gear boxes, but it’s generally much smoother than a Gear Box with Gears.
Changing a Power Steering Gear Box
If you’re experiencing a loss of power steering, there is a good chance that your power steering gear box is at fault. In this article, we’ll show you how to change your power steering gear box on your Volkswagen Golf R5.
First, make sure that your car is unplugged and the parking brake is off. Next, remove the front bumper and front fascia. Underneath these components you will find the power steering gear box and drive shaft. To access the gear box, disconnect the two bolts that hold it in place and then lift it out.
To replace the gear box, first disconnect the electrical connector from the front side of the gearbox. Then, remove the four screws that secure it to the engine block. Once these screws are removed, carefully slide the new gear box into place and secure it with the screws that were removed earlier. Be sure to reconnect the electrical connector before replacing the cover.
Tools Required
The following tools are required to change the power steering gear box on a vehicle:
-Power Steering Fluid (PSF)
-Power Steering Line Lock Tool
-Torque Wrench
-Jacked Up Vehicle
-Jack Stands
-Remote Disconnect
-High Pressure Washer
Procedure for Changing a Power Steering Gear Box
When it comes to changing a power steering gear box, there is a specific procedure that must be followed. If this process is not followed, the entire drivetrain could be ruined and the repair cost could be astronomical.
1. Remove the bolts that secure the power steering pump to the gearbox.
2. Lift up the gearbox and pull it out of the car.
3. If the gearbox has been leaking fluid, drain the old fluid and remove any debris from the gearbox.
4. Place a new sealant in all of the joints where the sealant will come in contact with metal. This will help protect against leaks in the future.
5. Reinstall the gearbox into the car, making sure that all of the bolts are properly tightened.
6. Replace any damaged parts, and restore any fluids that were lost during removal.
Conclusion
If you’re having trouble changing your power steering gear box, don’t worry – we’ve got the solution. In this article, we’ll show you how to change your power steering gear box without any difficulty or damage. By following our simple steps, you should be able to get your gear box changed in no time at all!