One of the most common car repairs is changing the power steering hose. In this article, we will show you how to do it step-by-step and make sure that the repair goes smoothly.
Locate the Power Steering Hose
When it comes to changing your power steering hose, you don’t have to break the bank to get a quality product. In fact, there are a variety of affordable options available on the market today.
First, you’ll need to locate the power steering hose. This can be done by looking under the hood or front bumper of your car. Once you’ve located it, you’ll need to unscrew the clamp that is attached to it. Once the clamp has been removed, you’ll need to pull the power steering hose off of the axle.
Next, you’ll need to replace the power steering hose with a new one. To do this, you’ll first need to measure out how much slack is in the hose. This will help determine how large a replacement hose you’ll need. Once you have determined how much slack there is in the hose, you can purchase a new one online or at your local car parts store.
Once the new power steering hose has been replaced, reattach the clamp and screw it back onto the axle. Be sure to test the function of your power steering system before reinstalling your vehicle’s cover and returning it to normal operation.
Disconnect the Power Steering Hose
When you’re ready to change the power steering hose, there are a few things you need to do first. First, disconnect the battery cable. Then remove the four bolts that hold the power steering reservoir cover in place. Finally, remove the power steering hose from the power steering pump.
To install the new power steering hose, first make sure that it’s the correct size by comparing it to the old one. Then thread it onto the bolt on the power steering pump and tighten it down with a wrench. Make sure that the seal is properly aligned and tightened before replacing the reservoir cover and re-connecting the battery cable.
Clean the Power Steering Hose
Your power steering hose is often one of the first places to show signs of wear and tear. In fact, it’s estimated that more than 50% of all power steering system failures are due to hose deterioration.
Here are a few tips for keeping your power steering hose clean and in good condition:
1. Regularly clean the power steering hoses as part of a general vehicle maintenance schedule. Use a bucket or large container and fill it with warm water and a detergent solution. Swish the hose around in the liquid to loosen any built-up dirt, oil, or grease. Pour the cleaner solution into the hose and allow it to soak for a few minutes before using a hose cleaner to scrub the entire length of the hose. Rinse off the hose with fresh water and dry it off before putting it back into service.
2. If you notice any sign of rust or corrosion on your power steering hose, replace it immediately. Hoses that are severely rusted or corroded will not only be ineffective, but they may also cause serious safety issues if they rupture while in use.
3. Be sure to store your power steering system away from moisture and excessive heat, both of which can damage
Reattach the Power Steering Hose
If you have replaced your power steering hose, you may find that it is difficult to connect the hose to the Power Steering Pump.
First, make sure that the Power Steering Pump is turned off. Next, disconnect the negative battery cable. Finally, loosen the four bolts that hold the Power Steering Pump cover on.
With the cover off, use a wrench to turn the pump until it is facing away from the car. Loosen the hose clamp and then slide the hose over the pump shaft. Reattach the clamp and tighten it using a wrench.