It’s common for dirt, dust, and other debris to build up in your power steering reservoir over time. If the reservoir becomes full of debris, it could prevent your car from moving correctly and lead to a lot of frustrating problems. In this article, we’ll show you how to clean out your power steering reservoir using simple techniques that you can do yourself.
What You’ll Need
To clean out a power steering reservoir, you’ll need the following:
– Reservoir hoses
-Container to hold the fluid
-Strainer
-Bucket
-Wire brush
-Clothing protection
-Soap and water
-Sandpaper or a grinder with a sanding disk
1. Disconnect the reservoir hoses from the gearbox. Be sure to disconnect both hoses at the gearbox and not just one.
2. Remove the cover on the reservoir.
3. Locate and remove the strainer (if present). If there is no strainer, simply pour out the fluid into a container.
4. Pour a little bit of soap into your bucket and add enough water to make a sudsy mixture. Swish the soap around in the bucket several times to mix it well.
5. Dunk the end of each hose into the sudsy mixture, making sure to get all of the dirt, grit, and debris off of it.
6. Hold one hose close to the bottom of the reservoir while you gently pour clean water into it from the other hose until it reaches the top of the reservoir. Use your hands to
How to Clean Out Power Steering Reservoir
If you have a power steering reservoir that needs to be cleaned, here are some tips:
1. Unplug the power steering system and drain the reservoir.
2. Remove the cover and hose clamp.
3. Use a turkey baster or syringe to squirt cleaner into the reservoir. Work the cleaner around and up into any crevices.
4. Replace the cover and hose clamp, plug in the power steering system, and wait 30 minutes for the system to purge any residual fluid.
5. Drive slowly around a few turns to check for any leaks, then drive normally.
Hints for Cleaning Out Power Steering Reservoir
If your car has a power steering reservoir, you’ll need to clean it out periodically. The reservoir collects dirt, dust, and other debris, which can over time cause the power steering to become harder to turn and may even lead to a breakdown. Here are some tips for cleaning out your power steering reservoir:
1. Remove the cover on the reservoir. This can be done by removing the screws that hold it in place or by prying it off with a plastic tool.
2. Use a hose to clear out the reservoir of all debris. If there is water inside the reservoir, be sure to remove it before you start cleaning.
3. Fill the reservoir with clean water and add a few drops of detergent. Swirl the water around inside the tank until the detergent is fully mixed in.
4. Wait 10 minutes and then drain the water from the reservoir. Pour a new batch of clean water into the tank and repeat steps 3-4.
Conclusion
If your power steering is failing to operate as it should, it’s likely that the reservoir has become clogged. This guide will walk you through the step-by-step process of how to clean out a power steering reservoir. By following these instructions, you’ll be able to get your car back on the road in no time!