When your baby starts to outgrow their car seat, it’s time to start thinking about getting a new one. But before you do, it’s important to know how to disassemble and reassemble the seat. This guide will show you exactly how. And if you ever have any questions about how to use your car seat or anything else related to it, don’t hesitate to reach out to Graco customer service. They’re always happy to help!
What is a Car Seat Turbobooster?
A car seat turbobooster is a device that helps to improve the acceleration of a car seat. It is a small, battery-powered device that attaches to the car’s sunroof and uses springs to help lift a car seat off the ground. This can help to improve the speed at which a car seat will move in and out of a vehicle, making it easier for parents to get their children into and out of their car seats.
How does a Car Seat Turbobooster work?
A car seat booster works by using a motor to increase the air pressure in your vehicle’s passenger compartment. When the air pressure is increased, it can help your child stay safer in their carseat. This is because a car seat that is not properly inflated can cause your child to slide around and become unstable. A booster also helps to support your child’s weight, which can make the carseat more comfortable for them.
How to disassemble a Car Seat Turbobooster
If you have a Graco Car Seat Turbobooster, it is time to take it apart. The seat has six parts: the base, the canopy, the shoulder belt guide, the middle belt guide, the height adjustment unit and the motor.
1. Start by removing the three screws that hold down the base. Then remove the base by lifting it up and pulling it away from the rest of the seat.
2. Next, remove the canopy by lifting up on one end and pulling it out of its mountings.
3. Undo the four screws that hold down both shoulder belt guides and remove them from their mounts. Then pull off both guides.
4. Loosen and then remove (with a screwdriver) both middle belt guides from their mounts on either side of the motor housing. Be careful not to lose any of these screws!
5. Carefully tilt and pull out (with a screwdriver) the height adjustment unit from its mountings on either side of the motor housing. It should come out easily enough but make sure all of its parts are accounted for – there are four screws holding it in place!
6. Finally, take apart (using a screwdriver)the motor housing by removing all eight screws that hold it together – four on each side.
Conclusion
The Graco Turbobooster is a great device for adding extra power to your car seat, but it can be difficult to disassemble and clean. This guide will show you how to take it apart and clean it properly. Be sure to follow the instructions carefully so that your car seat stays in good condition!