If you’re like most drivers, you often take for granted the power steering on your car. But if it’s not functioning properly, your driveability could be greatly affected. In this article, we’ll teach you how to find a leak in your power steering system so that you can fix it before it causes any more problems.
What to do if you notice a leak
If you notice a leak in your power steering, there are a few things you can do to address the issue.
1) Check the hoses and connectors. Make sure all the hoses and connectors are tight, and that there is no liquid or debris inside the hoses or connectors. If there is a leak, it will likely be undetectable unless you see liquid or debris leaking from the system.
2) Inspect the fluid level. If there is an obvious leak, the fluid level will likely be low. Check the fluid level using a dipstick or a syringe, and add more if needed.
3) Replace the power steering pump. If the leak is not due to a defective pump, it may be due to worn or broken components that need to be replaced.
How to find the source of the leak
Finding the source of a leak in your power steering system is important if you want to fix it. There are a few different ways to do this, and each has its own benefits and drawbacks.
One method is to use a pressure gauge to measure the cabin pressure. If the pressure is significantly lower than normal, then you likely have a leak in your power steering system.
Another option is to check for fluid leaks by putting a lighted candle near the power steering hoses and watching for flames. If there are any leaks, they will be apparent as flames.
If neither of these methods work or you just don’t have the time or equipment available, then you’ll need to scan for leaks using an infrared camera. This will allow you to see where the liquid is escaping from and whether it’s coming from one specific area or multiple locations.
How to repair the leak
If you’re experiencing a leak in your power steering, it’s time to take action. There are a few things you can do to try and fix the issue, and fortunately, most leaks are relatively easy to repair.
The first step is to identify the area where the leak is happening. This can be done by testing the power steering fluid level with a hydrometer or checking for rust around the power steering pump. Once you know where the leak is, it’s time to start fixing it.
The most common cause of power steering leaks is corrosion on the pump impeller or hoses. To fix this problem, you’ll need to clean all of the surfaces that are corroding and replace any worn parts. You may also need to seal off any cracks or holes in the pump housing.
If the leak is coming from the Novitec pump, you’ll also need to replace the impeller and seal off any openings on the housing. You should also replace any hoses that are leaking and flush out any system debris with fresh fluid.