Brake fluid is one of those things that you might not think about too often, but it’s important to keep it properly serviced and flushing if it starts to smell bad. This guide will show you how to flush brake fluid on a Harley Davidson motorcycle.
What is brake fluid and why do you need to flush it?
Brake fluid is a type of fluid that helps to stop a motorcycle or car from moving. Brake fluid is used in the braking system of a motorcycle or car. When brake pads wear down, the brake fluid becomes contaminated with dirt and dust. If the brake fluid is not flushed regularly, this contamination can cause the brake pads to wear out prematurely, which could lead to a failure in the braking system.
To flush the brake fluid on a Harley Davidson motorcycle:
1. Park your bike on a level surface.
2. Remove the front wheel.
3. Remove the rear wheel.
4. Use a wrench to unscrew the brake line nut at the bottom of each caliper (the one with a green washer).
5. Remove the two caliper pistons by popping them out with your fingers (use a wrench if needed).
6. Pour about 2 quarts of fresh brake fluid into each caliper bowl (it should fill up about three-quarters of the way). Replace all four caliper pistons and tighten the line nut back down.
7. Reattach the front and rear wheels, and verify that everything brakes smoothly by pressing down on each
How to flush brake fluid on a Harley Davidson
Brake fluid is a critical component of your motorcycle’s braking system. It helps to reduce the amount of friction that your brake pads create, which in turn allows you to stop more quickly. brake fluid gets dirty over time, and if it’s not flushed properly, it can cause your brakes to become ineffective. Here’s how to flush brake fluid on a Harley Davidson:
1. Park your motorcycle safely and turn off the engine.
2. Remove the front wheel and remove the brake caliper.
3. Open the bleed screws on both sides of the caliper and release the pressure from the brake system.
4. Pour a small amount of fresh brake fluid into each caliper bleed screw, being sure to avoid getting any on the rotors or suspension.
5. Replace the caliper and wheel and reinstall the front wheel.
6. Close the bleed screws on both sides of the caliper and re-pressurize the brake system.
What to do if your bike won’t start
If your Harley Davidson won’t start, there are a few things you can do to try and fix the problem. First, check the battery, cables, and connections. Next, check the oil levels and make sure they’re correct. Finally, if all of those checks come back clean, try flushing the brake fluid.
Conclusion
Brake fluid can be a messy business. If you’re not sure how to flush brake fluid on a Harley Davidson, this guide will walk you through the process step-by-step. By following these simple steps, you’ll be able to clean your bike and keep it running like new. Thanks for reading!