Recently, I had to remove a power steering pulley from my car. I read the instructions that came with the car and followed them to the letter, but I couldn’t get the pulley off. I was about to give up and call a tow truck when I remembered reading about a trick that worked on one of my old cars.
What is a Power Steering Pulley?
A power steering pulley is a metal or plastic device that is attached to the engine and helps to move the power steering pump and coupling. It can become stuck on objects or if it becomes damaged, which can cause the car to become difficult to steer.
If you are unable to remove the power steering pulley yourself, you may need to enlist the help of a professional. Some people use a pulley puller, but this may be too difficult or dangerous for some people. Instead, you may be able to remove the pulley by using a wrench and a bolt socket.
How do I remove a power steering pulley without a puller?
If you have a 2006-2008 Toyota Camry or 2007-2009 Lexus LS, then you may be in for a bit of a challenge when it comes to removing the power steering pulley. The pulley is held on by six bolts that are located around the circumference of the pulley. Unfortunately, these bolts are not accessible from the outside and require the use of a puller in order to remove them. If you don’t have access to a puller, there is still a chance that you can remove the pulley without any hassle by using a wrench and socket.
First, locate the six bolts that hold the pulley onto the shaft. Use a wrench to secure the socket onto the bolt and then slowly turn it until it starts to come off. Once it’s loose, use your fingers to twist it off of the shaft. Be careful not to damage the pulley while removing it!
How to remove a power steering pulley with a puller
If you find yourself needing to remove a power steering pulley but don’t have a puller, there are a few things that you can do. First, try using a wrench. If that doesn’t work, try using a socket wrench. Finally, if those methods fail, you can use a hydraulic jack to pry it off.
Conclusion
If you’re struggling to get power steering pulley off your car without a puller, don’t panic! There are several ways to do it and the one that works best for you will depend on the type of pulley and how tight it is. In most cases, you can use a wrench to loosen the bolts that hold the pulley in place. You may also need to apply pressure from the bottom side of the wrench so that it presses against the bolt head. If this doesn’t work, you may need to use a puller.