The days of the child carseat being installed by the child are long gone. nowadays, most parents are required by law to use a car seat that’s installed using a base and a shoulder belt. This video demonstrates how to install a Graco car seat base with a shoulder belt. If you have any questions or doubts about how to install your car seat using this method, be sure to watch the video for clarification.
Preparing Your Vehicle
Installing a Graco car seat base with shoulder belt can make traveling with your child in the car much safer. Here’s how to do it:
1. Locate the shoulder belt anchor points on your car’s chair-seat backrest and frame. These points should be directly behind your child’s ears and at least 1 inch (2.5 cm) apart. If they’re not, you’ll need to adjust them so that they are.
2. Insert the strap into one of the anchor points and pull tight. Make sure the buckle is closed all the way and snap the other strap into the other anchor point.
3. Raise your child into position in their car seat, ensuring that their head is positioned above the level of their lap and that their knees are bent to 90 degrees or less (healthy children should not sit with their heels hanging off the edge of a seat).
4. Reach behind your child’s neck and pull up on either side of their collar until both straps are taut, then tighten them slightly against her back using a clasp or buttons as necessary [image: image]. The shoulder belt should now fit snugly around her chest and waist without being too tight or too loose [image: image].
5. You’re done! You can now safely transport your child in their car seat without having to worry about them falling out or hitting their head on something while driving [source: Graco].
Installing the Graco base
If you have a Graco car seat base with shoulder belt, follow these steps to install it:
1. Open the seat base and place it on the vehicle in the desired seating position.
2. Install the twobumper connectors to each side of the seat base.
3. Install the shoulder belt by threading it through both connectors and around your child’s waist.
4. Close the seat base and tighten the shoulder belt straps.
Installing the shoulder belt
Installing the Graco Car Seat Base with Shoulder Belt is a simple process that should take no more than a few minutes. To install the base, follow these steps:
1) Open the car seat base and remove the backrests.
2) Attach one clip to each side of the backrest and insert them into the slots on the base.
3) Push down on the clips until they are tight. The clips will hold the backrest in place while you install the shoulder belt.
4) Repeat Steps 2-3 for the other side.
5) Insert one end of the shoulder belt through a slot in one of the clips and pull it tight. Then, do the same with the other end of the belt. You’re done!
Tips for Safe Driving with a Graco car seat
There are a few safe driving tips to keep in mind when using your Graco car seat.
1) ALWAYS use the correct installation method for your Graco car seat. There are three types of Graco car seats: infant-only, convertible and combination. Make sure you install the car seat according to its type so it will fit properly and stay secured while you’re driving.
2) NEVER use a tether if you can avoid it. A tether may cause your child to become over-tethered, which could lead to them becoming stuck in the vehicle or getting injured in a crash. If you must use a tether, make sure it’s long enough so it doesn’t come into contact with your child’s body and securely fastened to the vehicle.
3) NEVER leave your child unattended in a parked car. Wait until you’ve safely arrived at your destination before unbuckling them and bringing them inside. Leaving an infant alone in a car can be dangerous not just for them, but also for other drivers on the road.