There are certain times in life when you need to be able to start your car without having to fumble around for your keys. These times might include when you’re driving in a big city or when there’s a lot of traffic. In these situations, it can be inconvenient to have to search through your pockets for your keychain and find the ignition switch. If this happens to you and you don’t know how to install an ignition switch, don’t worry—this guide is for you. In just a few short steps, we will walk you through the process of installing an ignition switch in a 93 Lincoln Town Car Executive.
What is the Ignition Switch?
The ignition switch is a key part of your Lincoln Town Car. It controls the engine and can help prevent theft and accidents. If your Town Car has an automatic transmission, the ignition switch may be located in the gear selector lever. If your Town Car has a manual transmission, the ignition switch may be located on the dashboard.
How to Install an Ignition Switch
In this article, we will show you how to install an ignition switch in a Lincoln Town Car. This is a required job if you have a 2004 or newer Lincoln Town Car. The installation of the ignition switch is easy and can be completed in about 30 minutes.
To start, open the hood of your car and locate the fuse box. Underneath the fuse box should be a black box with wires coming out of it. This is the ignition switch. If your car has airbags, they may need to be disabled before you can do anything else. Next, remove the cover on the black box by prying it up with a flathead screwdriver. You may need to use a T-bar tool to twist it off (see picture). It’s best to disconnect all of the wires before doing this so you don’t mix them up later.
Now that the cover is off, you’ll see 4 screws holding on the switch housing (1 on each side). Remove these screws and lift off the housing (2 pieces). Be careful not to lose any of the screws or springs!
Next, take a look at the wiring inside of the housing. There are 3 white wires going into it and 1 brown wire
Steps to Take After Installing the Ignition Switch
There are a few steps that need to be taken after installing the ignition switch in a Lincoln Town Car. First, turn the car off and remove the key from the ignition. Next, disconnect the ground wire from the battery. Finally, remove the old ignition switch and install the new one.
Conclusion
If you’re looking to install an ignition switch on a 93 Lincoln Town Car Executive, our guide below should help you get the job done right. By following the step-by-step instructions in this article, you’ll be able to replace your old ignition switch with a new one without any trouble at all. If you have any questions or concerns while installing your new ignition switch, don’t hesitate to reach out to our team of experts for assistance. Thanks for reading!