If you’re experiencing trouble with your Chevy 350’s power steering, there is a good chance that the pump and brackets are missing or damaged. In this article, we’ll show you how to install the pump and brackets, and help you troubleshoot any issues that might arise.
What you need
To install a power steering pump and brackets on a Chevy, you will need the following items:
-A power steering pump
-A bracket kit
-Two bolts (8 mm)
-A screwdriver
-A wrench
-A container of lubricant
1. Start by checking your battery to make sure it is fully charged. If your battery is low, you will not be able to install the power steering pump or brackets.
2. Open the hood of your car and locate the power steering pump. It should be located on the front right side of the engine.
3. Next, locate the bracket kit. The bracket kit should come with instructions that will tell you where to mount the pump and how to connect it to the brackets.
4. Take the screws out of the bracket kit and put them in the bottom of the pump. Then take the bolts that came with the bracket kit and put them in the screws, so that they are tight.
5. Next, connect one end of the hose from the pump to one of the brackets. Make sure that you fasten this end securely so that it doesn’t move around during driving.
6. Connect another
How to install power steering pump and brackets Chevy 350
If you’re looking to install power steering pump and brackets Chevy 350, here’s a quick guide on how to do it.
1. Remove the wheel and take off the hubcap.
2. Underneath the car, remove the four bolts that hold the steering rack to the axle.
3. On each side of the car, remove the two bolts that hold the power steering pump to the bracket.
4. Remove the power steering pump and brackets from the car.
5. Install new power steering pump and brackets onto the car, making sure to match up holes on each side of the car.
6. Replace bolts and hubcap and re-attach wheel.
Final thoughts
When it comes to installing a power steering pump and brackets on a Chevy, there are a few final thoughts that need to be considered. First and foremost, make sure that the power steering system is properly dismantled in order to avoid any damage. Next, make sure that all of the necessary brackets and parts are ordered ahead of time so that installation can proceed smoothly. Finally, take care when installing the pump itself so that no damage is done to the vehicle or its components.