How To Install Power Steering Pump Pulley Without Tool

A power steering pump pulley can become a pain to replace if you don’t have the right tools to get the job done. In this article, we’ll show you how to install a power steering pump pulley without a tool using basic automotive mechanics.

What is a power steering pump pulley?

A power steering pump pulley is a component of a power steering system. It is an accessory that helps to transmit the power from the engine to the power steering pump. Without a pulley, it would be difficult for the engine to provide enough power to move the pump and gear box.

How to install a power steering pump pulley without tools

If you’re like most car owners, you probably dread having to replace a power steering pump. In fact, it’s probably the most annoying and time-consuming repair you’ll ever have to make on your car.

However, thanks to a few simple tools and a little know-how, installing a power steering pump pulley is a quick and easy task that can be accomplished without any special tools or expertise.

Here’s how to do it:

1. Disconnect the battery cable and the negative terminal of the battery. Make sure the parking brake is set and remove any objects that may get in the way of the work.
2. Mark the position of both pulleys on the pump using a marker or piece of tape. The pulley on the right side should be located about 1 inch above the bracket that attaches it to the engine block and 3 inches behind the front edge of the pulley on the left side.
3. Remove the power steering pump by unscrewing it from the bracket. Be careful not to twist or damage either end of the pump shaft while you’re removing it.
4. Carefully place one end of the pulley shaft into one of the holes

See also  Can You Add Power Steering Fluid Without Flushing

What to do if the power steering pump pulley doesn’t fit

If your power steering pump pulley doesn’t fit on your vehicle, there are a few things you can do to try and fix the issue. First, make sure that the pulley is the correct size for your vehicle. If it isn’t, you may need to order a new one. If that doesn’t work, you can try using a tool to remove the pulley from the motor shaft. However, this is usually only necessary if the pulley is severely stuck on the shaft.

Conclusion

If you’re struggling to install a power steering pump pulley without the use of a tool, don’t worry – there is an easy solution. First, remove the bolts that are securing the power steering pump to the engine block using a wrench. Next, disconnect the hose that connects the power steering pump to the transmission by unbolting it and pulling it away from the truck. Finally, grab hold of the pulley with one hand while slipping a shop towel underneath it so you don’t scratch your truck’s finish. Use your other hand to twist and pull until the pulley is free from its housing and ready for installation.

DynoCar is the best place to find information on all things cars, whether it be a car buying guide or how to change your oil. We’ve made finding and staying in touch with car information easy and fast.

Resources

Guides

About Us

Contact

Contact

DynoCar - All About Cars

(440) 999 3699

590 Monterey Blvd San Francisco, CA 94127

Information contained herein is for informational purposes only, and that you should consult with a qualified mechanic or other professional to verify the accuracy of any information. DynoCar.org shall not be liable for any informational error or for any action taken in reliance on information contained herein.