Car jacking is a frightening reality for many people. It’s not just the physical act of grabbing someone’s car and taking off, but the psychological damage that can be done to the victim as well. In this article, we’ll show you how to make car jack stands so that you can protect yourself from carjackers.
What You’ll Need
To make your own car jack stands, you’ll need the following supplies:
-Two large rocks or bricks
-A sturdy piece of wood
-An 8″ section of ¾” PVC pipe
-A 1/2″ slip fit elbow fitting
-A T lock connector (or equivalent)
-Permanent marker
1. Begin by measuring the circumference of your wheel well. This will be the size of your rocks or bricks. Your PVC pipe will then need to be cut to this size.
2. Cut a hole in one of the rocks or bricks to fit your PVC pipe. Make sure that it is big enough so that the rock or brick can sit flush with the hole, but not so big that water can get inside.
3. Mark where the hole is on the brick/rock using a permanent marker.
4. Drill a hole in the center of the PVC pipe, just large enough for the T lock connector (or equivalent) to fit through. Push the connector through the hole and screw it into place.
5. Fit the other end of the PVC pipe into one of the holes on your wood panel, making sure that it is lined up correctly.
How to Make It
If you’re looking for a simple and easy way to secure your car with a jack stand, then you’ll love this DIY car jack stand tutorial. You’ll need a sturdy piece of wood, some screws, and a drill.
1. Measure the length of your wood board and cut it to that size.
2. Drill holes along the length of the board so that screws can be inserted.
3. screw the board to the wall or post where you want it mounted.
4. Make sure the wood is flat against the wall or post before finishing up the project by sanding it down if necessary.
Tips for using a car jack stand
When you need to use a car jack stand, there are a few things to keep in mind. First, make sure that the area you are working in is level. If the surface is not level, the jack will not be able to hold the car securely and it will likely fall over. Second, choose a jack stand that is sturdy and well made. Cheap car jack stands may not be able to hold the weight of the car and may eventually fail.
Finally, be careful when using the jack stand. Always use caution when lifting anything heavy, especially if you do not know how strong the anchor is or if it has been used before. If everything goes according to plan and you are using a safe and sturdy jack stand, you should be able to get your car up quickly and without any problems.
Conclusion
If you’re like most drivers, you’re always looking for ways to make your driving experience easier. One way to do this is by installing car jack stands in strategic places around your driveway so that you can easily change a tire when needed. Not only are car jack stands an essential part of any driver’s arsenal, but they also come in handy if you’ve got a lot of heavy equipment or furniture in your garage. If you’re ready to take your parking experiences to the next level, check out our selection of car jack stands and get started today!