One of the most common repairs that car owners will have to make is replacing a power steering pulley. In this article, we’ll show you how to do it without removing the entire steering wheel.
What is a power steering pulley?
A power steering pulley is a system located on the engine that helps to provide power to the steering system. It is also responsible for transferring power from the engine to the pump that provides hydraulic pressure to the steering system.
How to replace a power steering pulley
If you’re having problems with your power steering, it may be time to replace your pulley. Here’s how to do it:
1. Park the car in a safe place, preferably on a level surface.
2. Remove the battery cover and disconnect the negative battery cable.
3. Disconnect the gearbox oil filler cap and drain the oil into a suitable container.
4. Remove the front grille by unscrewing the two screws at the top and then pulling it forwards.
5. Locate and remove the power steering pump assembly (see photo). If necessary, use a hacksaw to cut off one of the discharge hoses before removing it.
6. Loosen each bolt that holds the pulley on each side and then lift it off (see photo). Be careful not to lose any of the washers or springs!
7. Inspect the pulley for damage (e.g., cracks or broken teeth) and replace it if necessary. Note that there is usually only one pulley per side so be sure to match up replacements from both sides!
8. Reinstall all bolts, washers and springs in reverse order, making sure that they are tightened evenly. Replace the
How to fix a power steering pulley
If you’re experiencing difficulty turning your car or if the power steering is not working at all, it’s likely that you need to replace your power steering pulley. Here’s how to do it:
1. Park your car in a safe place and turn off the engine.
2. Remove the front wheel covers and the air filter.
3. Loosen the bolts that hold the power steering pump to the chassis (see image below).
4. Carefully remove the power steering pump from the chassis, noting which pulley it attaches to (see image below).
5. Disconnect the belt and idler pulleys by unscrewing their bolts (see image below).
6. Now you can remove the old pulley from the pump by gently pulling it out (see image below).
7. Clean both the old and new pulleys with a cloth, alcohol, or WD-40 before re installing them on the pump. Tighten all bolts to 98 Nm (79 ft lbs).
Conclusion
If you’re having trouble with your power steering pulley, it might be time to give it a once-over. Here are some tips for pressing on the pulley and fixing any problems that may exist: 1. Try using a pressurized air rifle to pry off the old pulley. Use caution not to damage the serpentine belt or other internal components. 2. If using a pressurized air rifle is not an option, try using a hydraulic jack to pry off the old pulley. Be sure to use a protection device such as a hoist or guardrail when doing this so that you don’t injure yourself or bystanders. 3. If removing the Pulley is not possible then replace it with a new one – there’s no need to go through all of this trouble if something as simple as replacing the Pulley can solve your problem!