If you’re having trouble getting your car out of a tight parking spot, or if you’re just having trouble turning the wheel in general, it might be time to check out your power steering pulley. This small but important part of your car’s engine can often give you problems if it’s not functioning properly. In this article, we’ll show you how to press the pulley on your car and fix any issues that might be causing the problem.
Unfasten the screws that hold the power steering pump pulley in place
If you need to replace your power steering pump pulley, it’s important to first remove the old one. To do this, you’ll need to unfasten the screws that hold it in place. Here’s how:
1. Start by locating the screws that hold the power steering pump pulley in place. They’re located on either side of the pump itself.
2. Using a Phillips head screwdriver, unscrew the screws until they’re free. Be sure to note which side they’re on so you can reattach them in the same location when you’re done.
3. Once the screws are free, lift up the power steering pump pulley and remove it from the car.
Turn the power steering pump pulley so it’s facing the engine
Step 1: Locate the power steering pump pulley on the engine. It’s usually on the front or top of the engine.
Step 2: Look for a v-shaped notch in the pulley. This is where you’ll need to press it onto the shaft.
Step 3: Push down on the pulley until it’s firmly seated on the shaft.
Use a socket or ratchet to remove the bolt that holds the power steering pump pulley in place
If you have trouble removing the power steering pump pulley bolt, there is a socket or ratchet that you can use to help. Simply place the socket over the bolt and twist it until it comes off. Alternatively, use a ratchet to turn the bolt until it comes off.
Push the power steering pump pulley off of the engine and set it aside
When you’re done working on your car, it’s a good idea to take care of the small pieces first. One of these small pieces is the power steering pump pulley.
Push the pulley off of the engine and set it aside. You can do this by prying it off with a screwdriver or a wrench. Be sure to place it in a safe place so you don’t lose it later.
Now that the pulley is out of the way, you can clean everything up with a cloth or a vacuum cleaner. Make sure to remove all of the dirt, grease, and dust from the pulley and its surrounding area.
Replace the bolt that held the power steering pump pulley in place and tighten it using a socket or rat
Replacing the bolt that held the power steering pump pulley in place and tightening it using a socket or rat can fix many problems with slipping or poor power steering.