In this article, we will be teaching you how to put a jack on a car. This is an essential skill if you own a car and want to be able to fix it yourself in the future. We will go over the steps needed and provide a video tutorial along the way.
Tools You’ll Need
In order to put a jack on a car, you’ll need the following:
-A jack
-A wrench
-An axle wrench
-A bucket or a large container that can fit under the car
-Pliers
-A screwdriver
-Tape measure
-An Allen wrench
-A crowbar or a piece of metal sturdy enough to hold the weight of the car
-Boots
The Process
If you’re looking to do some simple car repairs, like adding or replacing a jack, there are a few steps you need to take. Here’s how to put a jack on a car:
1. Locate the jacking point on the car. This will likely be near the back or front of the vehicle.
2. Unscrew the bolts that secure the bracket to the vehicle.
3. Lift up the bracket and place it on the ground next to the car.
4. Fit the arm of the jack onto the bracket and tighten the bolts with a wrench.
5. Position the car so that it is balanced on all four tires and push down on the arm of the jack until it touches bottom of wheel being lifted.
6. Remove one bolt at a time until it’s free from the wheel and replace with a new one.
Tips For Putting A Jack On A Car
If you have a car that needs a jack, there are a few things you’ll want to take into account.
Before starting, be sure to verify that your car has a 12-volt electrical system. Most cars made after 1996 do, but some older models may not have this capability. If your car doesn’t have a 12-volt electrical system, you’ll need to find an appropriate power source before continuing.
Remove all the items from the trunk or inside the car that could be in the way of the jack. This includes anything that could trip the alarm and cause the car to start.
Position the car on level ground with the frame straight and center over the axle nut. Next, place protective pads under both front and rear wheels.
Make sure your breaker is off before turning on the ignition. You don’t want to start the car and then have it seize up because you used too much electricity to jack up the car!
Connect the positive (+) end of the battery cable to the positive (-) end of the car’s battery. Connect the negative (-) end of the cable to an appropriate receptacle, such as a grounding station or an unused outlet in your home.
Conclusion
Putting a jack on your car can be a tricky task- but with the right tools and instructions, it shouldn’t be too hard. In this article, we will show you how to put a jack on your car using the correct tools and techniques. First, make sure that you have all of the necessary items: a jack, an adjustable wrench, and some rope or straps. Next, loosen the bolts that hold the suspension in place by turning them counterclockwise with the adjustable wrench. Once these bolts are loosened, raise the vehicle using the jack until it is at least 2 inches off of ground level. Now use the ropes or straps to secure it in place while you tighten down the bolts by turning them clockwise. Be careful not to over-tighten these bolts- if they are too tight, they could damage your car’s suspension. Finally, remove the ropes or straps and enjoy your newly installed jack!