Putting a pulley on a power steering pump may seem like a daunting task, but with our easy-to-follow guide, you’ll have it done in no time! We’ll walk you through the entire process, step by step, so you can get back to driving your car as soon as possible.
Location of the power steering pump
The power steering pump is located on the driver’s side of the engine, near the firewall. It is usually a black, oblong shaped object. There will be a large hose attached to it, as well as a smaller return hose. The pulley is located on the end of the shaft coming out of the pump.
The tools you’ll need
In order to put a pulley on a power steering pump, you’ll need a few tools. Firstly, you’ll need a wrench to loosen and remove the old pulley. Secondly, you’ll need a socket and ratchet to remove the mounting bolts. Finally, you’ll need a pulley installation tool, or an impact wrench, to install the new pulley.
With these tools in hand, follow the steps below to successfully install your new pulley.
How to remove the old pulley
If your power steering pump has a pulley that’s worn out or damaged, you’ll need to replace it. Here’s how to remove the old pulley:
1. Disconnect the battery.
2. Loosen the bolts that hold the pulley in place.
3. Remove the old pulley and discard it.
4. Clean the power steering pump shaft before installing the new pulley.
5.Install the new pulley and tighten the bolts securely.
6. Reconnect the battery and test drive your vehicle to make sure the power steering system is working properly.
How to install the new pulley
If you have a power steering pump that needs a new pulley, the process is actually pretty simple. You’ll just need a few tools and to follow these steps:
1. Remove the old pulley. This will usually involve removing a few bolts that hold it in place.
2. Install the new pulley. Again, this will usually involve bolting it into place.
3. Make sure the new pulley is properly aligned. This is important for the proper functioning of your power steering pump.
4. Test out your power steering pump to make sure it’s working properly with the new pulley installed.
Tips for making the job easier
1. If you’re having trouble getting the old pulley off, try using a strap wrench.
2. Make sure to clean the new pulley before installing it.
3. When putting the new pulley on, use a socket that’s slightly smaller than the pulley so it doesn’t slip off while you’re tightening it.
Conclusion
If your power steering pump has stopped working, it’s likely that you’ll need to put a new pulley on it. While this may seem like a daunting task, it’s actually relatively simple to do. With a few tools and some patience, you can have your power steering pump up and running in no time. Thanks for reading and good luck!