In this article, we will teach you how to put a car on four jack stands. This is an important skill for anyone who works on cars, and it can come in handy for a variety of repairs.
What You’ll Need
To put a car on a jack stand, you’ll need the following items:
-A jack stand
-A car
-Safety gear
-A jack handle
Here’s how to do it:
1. Find a jack stand that is sturdy and large enough to hold the car securely. Make sure that the stand is level and plumb so that the car will not touch any surfaces during the procedure.
2. Secure the car with safety gear, such as a anchor lock. Make sure the gear is tight so that it doesn’t move while the car is on the jack stand.
3. Insert the jack handle into one of the wheel wells and push down until it connects with the lug nut on the wheel.
4. Tighten the lug nut by turning it counterclockwise with your hands. Be careful not to over-tighten it, as this could cause damage to the wheel well or tire.
5. Repeat these steps for each wheel on your car.
How To Put Car On Jack Stands
If you’re planning on doing some work on your car, you’ll need to first find a jack stand that will work with your vehicle. There are a few different types of jack stands, so be sure to select the right one for your vehicle.
To use a jack stand, first find the hole in the trunk or engine bay of your car that corresponds to the bolt that fastens the jack to the stand. Locate the bolt and unscrew it. Next, insert the arm of the jack stand into this hole until it’s snug against the car. Screw the bolt back in place.
Now you can start raising and lowering your car using the jack stand as support. Be careful not to over-torque the bolt, or you may damage your car. When you’re finished working on your car, lower it back down and unscrew the jack stand from the car.
Tips For Putting A Car On A Jack Stand
To put a car on a jack stand, first make sure the car is turned off.
Next, remove the key from the ignition.
You will also need to remove the front wheel.
Next, use a wrench to loosen the bolts that hold the jack stand in place. Be careful not to damage the jack stand or the car.
Once the bolts are loosened, lift the jack stand into position. Position it so that it is level with the wheel hub. Tighten the bolts back into place.
Now you can remove the wheel and tire. Be sure to safety check them before putting them away.
Conclusion
Putting a car on four jack stands is not as hard as you might think. In fact, it’s pretty straightforward and can be done in just a few minutes with the right tools. If you have never attempted to do this before, or if you’ve tried it and had trouble, read our guide below to learn the basics of putting your car on four jack stands and get started.