When you’re out and about, there are a few things you never want to see: A big, red “X” on the side of a car. This is usually the sign that a child has been in a crash and is being taken to the hospital. Maxi-Cosi Mico car seats are some of the most popular around, but they can also be one of the most difficult car seats to put back on properly. In this blog post, we will teach you how to put Maxi-Cosi Mico car seat cover back on in just minutes!
Locate the Maxi-Cosi Mico Car Seat Cover
To put the Maxi-Cosi Mico Car Seat Cover back on, follow these steps:
1. Align the Velcro tabs at each end of the cover with the corresponding Velcro strips on either side of the car seat.
2. Push down on one corner of the cover until it clicks into place in the slots on either side of the car seat.
3. Repeat on the other corner, and then pull up on both ends to tighten.
Remove the Buckle
If you have a Maxi-Cosi Mico car seat, and need to remove the buckle for cleaning or travel, follow these easy steps:
1. Unbuckle the car seat from the base.
2. Grab one loop of fabric near the buckle on one side of the car seat, and pull up.
3. Hold on to that loop while you unsnap the other loop from near the base of the car seat.
4. The two loops should now be free, and you can easily unbutton them and clean under them.
Pull Down the Velcro Straps
If your child’s car seat cover has Velcro straps, it’s easy to put it back on. First, make sure the cover is in the correct position. Then, pull down the Velcro straps.
Reattach the Buckle and Velcro Straps
In this how-to guide, we will show you how to reattach the buckle and velcro straps of your Maxi-Cosi Mico car seat cover. This is a quick and easy process that can be completed in just a few minutes.
First, make sure the car seat is positioned in the desired position on the vehicle floor. Next, remove the velcro strap from the back of the car seat. Finally, attach the buckle strap to the front of the car seat. Be sure to overlap both straps by at least 2 inches (5 cm).
Repeat for the Second Side
Instructions
1. If your car seat has a cover, remove it.
2. Locate the two straps that connect the cover to the car seat.
3. Carefully pull up on both straps until the cover is loose from the car seat.
4. Place the cover on a flat surface.
5. Align the Velcro tabs at one edge of the cover with corresponding Velcro tabs on the car seat, and press down to secure cover in place.
6. Repeat steps 3-5 for the second side of the car seat cover.