It is not uncommon for a power steering pump to develop a leak. If you have ever had to add fluid to your power steering reservoir, then you know that this can be a messy and difficult job. But it doesn’t have to be! With a few simple tools, you can easily replace the pulley on your power steering pump in no time.
Remove the old power steering pump pulley
1. Remove the old power steering pump pulley. 2. Install the new power steering pump pulley. 3. Tighten the new power steering pump pulley in place. 4. Reattach the power steering pump to the engine. 5. Test drive your vehicle to make sure the new power steering pump pulley is working properly.
Clean the power steering pump pulley shaft
Assuming you have the power steering pump out of the car:
1. Clean the power steering pump pulley shaft with a rag and brake cleaner. Make sure to clean any grooves or slots in the shaft.
2. Inspect the power steering pump pulley for any damage. If there are any cracks or chips, replace the pulley.
3. Grease the power steering pump pulley shaft with a light coat of grease.
4. Install the new power steering pump pulley onto the shaft. Make sure it is fully seated and aligned properly.
5. Tighten the power steering pump pulley nut to specifications using a torque wrench.
Install the new power steering pump pulley
1. Remove the old power steering pump pulley.
2. Install the new power steering pump pulley.
3. Tighten the bolts to secure the pulley in place.
4. Reconnect the power steering pump to the power steering system.
5. Test the power steering system to ensure it is working properly.
Torque the power steering pump pulley bolt to specifications
If you’re looking to replace or install a power steering pump pulley, it’s important to torque the bolt to the proper specifications. Depending on the make and model of your vehicle, these specs can vary. But in general, most power steering pump pulleys should be torqued to between 18 and 25 ft.-lbs.
Additionally, make sure to use the correct size wrench or socket when tightening the bolt. Using a tool that’s too large or small can damage the bolt, making it difficult to remove in the future.
Re-install the power steering belt
If your car has power steering, then you have a power steering pump. This pump is responsible for providing the hydraulic pressure that helps you turn the wheel. Over time, the pump can start to leak, and this can cause the power steering to fail. If this happens, you’ll need to replace the power steering pump.
One of the most difficult parts of replacing the power steering pump is putting the new one on. This is because the pulley that drives the pump is located in a difficult spot. Here are some tips on how to put a new pulley on a power steering pump:
1. Remove the old power steering pump. This will give you better access to the pulley.
2. Take off the old pulley. You’ll need a wrench or socket to do this.
3. Put the new pulley on the shaft of the new power steering pump. Make sure that it’s tight so that it doesn’t come off while you’re driving.
4. Re-install the power steering belt. This can be tricky, so make sure that you follow the instructions in your car’s manual.
5. Test-drive your car to make sure that everything is working
Start the engine and check for leaks
If there are no leaks, the next step is to add power steering fluid. With the engine off, remove the power steering pump cap and add fluid until it reaches the “full” line on the dipstick. Replace the cap and start the engine. Check for leaks again and add fluid as necessary.
Conclusion
If you need to replace your power steering pump or are simply looking to upgrade it, then you’ll need to know how to put a pulley on power steering pump. It’s not a difficult task, but one that requires a little bit of know-how. We hope that our guide has given you the information you need in order to successfully install your new power steering pump.