Putting seat covers on your car may seem like a simple task, but it can be a bit more complicated than you think. In this blog post, we will walk you through the process of putting seat covers on your car step-by-step. From measuring your car to finding the right materials, we will cover everything you need to know in order to get the job done correctly.
Tools You’ll Need
To properly install seat covers on your car, you’ll need a few tools. The most important of these is a flat head screwdriver. Other tools you’ll need include a seat cover opener, scissors, and a ruler or measuring tape.
To start, measure the width of the seat cover opening. This will be the widest part of the cover. Then, measure the length of the opening. This will be the length of the cover fabric minus 1 inch (or 2.5 cm). Finally, add 1 inch (or 2.5 cm) to both measurements to account for seam allowances.
Next, cut out the cover fabric using your scissors. Make sure to cut along the straight lines that you measured earlier! You can then fold over each end of the fabric so that it forms a smooth edge and press it down with your fingers.
Finally, mark where each screw goes on your car’s seat backs using your ruler or measuring tape. Then, use your screwdriver to attach each end of the fabric to one of the screws on either side of your seat back. Be sure to tighten each screw firmly before moving on to the next one!
How to Put Seat Covers On Your Car
If you live in a warm climate, your car will be covered in pollen, dust and other allergens every single time you drive it. Not only is this unsightly, but it can also be quite dangerous if you have any respiratory conditions.
To avoid this problem, you can put seat covers on your car to keep things clean and pollen-free while you’re driving. Here are the steps on how to do it:
1. Decide what type of seat cover you want to use. There are several different types available, including fabric covers that attach with Velcro or elastic bands, fleece covers and even air conditioning insulation covers.
2. Clean the surface of your seats with a cloth or a vacuum cleaner before attaching the cover. This will remove any oils or dirt that could interfere with the adhesive’s ability to stick.
3. Measure the width of the cover across the top and bottom of each seat cushion and compare it to the width of each seat belt webbing bracket. If there is a discrepancy, make sure to trim off any excess material before attaching the cover.
4. Select an adhesive that is appropriate for your covering material and apply sufficient pressure to adhere the cover to both sides of each cushion.
Tips for Putting Seat Covers On Your Car
There are a few tips to keep in mind when putting seat covers on your car.
First, make sure the cover is the right size. Most covers are designed to fit most sedans and SUVs.
Secondly, be sure that the cover is securely fastened to the vehicle. Some covers use snaps or Velcro, while others have straps that must be tightly secured around the seat frame.
Thirdly, ensure that all windows and mirrors are covered so that no light comes through and obscures your view.
And finally, if you’re using a rear-facing infant carrier or child safety seat, make sure the cover fits tightly around it so it doesn’t move around during travel.