If your Saginaw power steering pump is going bad, it’s time to rebuild it! Power steering pumps are essential components of vehicles, and if they go bad, you’ll find yourself struggling to steer the car. In this article, we’ll teach you how to rebuild a Saginaw power steering pump using simple DIY techniques.
What is a power steering pump?
A power steering pump is a device that helps turn the wheels of a car. It works by using pressure to move the vehicle forward or backward. Pumps are usually made of metal, and they are attached to the steering wheel in order to help turn it.
How do power steering pumps work?
When a driver turns the steering wheel, the power steering pump sends a pressurized lubricant to the power steering gearbox. The power steering gearbox turns the shaft that connects to the front axle, which in turn moves the vehicle’s wheels.
Pumps work by using a Wheeling Pressure Plate (WP) and Rotor (RR). When the WP is pressed down, it causes the RR to spin faster and create more pressure. This high pressure pushes oil through tiny passages into the pump’s bearings and reservoir. As soon as this oil flow stops, the WP rebounds and sends more pressure to the RR, causing it to spin even faster and continue pumping oil.
What are the symptoms of a power steering pump failure?
A power steering pump failure can cause a variety of symptoms, including:
-A loss of power or sluggishness when you turn the wheel
-Slower than normal steering
-A whining or grinding noise coming from the engine or the vehicle
How do you rebuild a power steering pump?
Replacing a power steering pump is a relatively easy and affordable DIY job for those with some mechanical know-how. Follow these steps to get started:
1. Remove the old power steering pump. This can be done by removing the four screws that hold the pump in place, or by using a lever to pry it off. Once it’s free, disconnect the hoses and lines connected to it.
2. clean and inspect the old pump before you start replacement. Rust and debris can accumulate on the inside of a power steering pump over time, which can cause it to malfunction or fail outright. Clean all of this away with soap and water before you begin.
3. Buy a new power steering pump. There are many brands and types of pumps out there, so it’s important to find one that fits your car properly. Many new pumps can be found online or at your local dealership.
4. Install the new pump in the same way as the old one – by installing screws or using a lever – and connect all of the necessary hoses and lines. Test the system to make sure everything is working properly before you go ahead and cover everything up again!
Conclusion
If your Saginaw power steering pump has failed, don’t despair! There are a few things you can do to rebuild it yourself, and if you’re feeling up for the challenge, we’ll walk you through each step. In the end, though this project may take some time and patience (and maybe a little extra money), it will be well worth it to have a working power steering pump again. So let’s get started!